aboutsummaryrefslogtreecommitdiff
path: root/drivers/bus/uniphier-system-bus.c
blob: f70dedace20b4ec4c06535453d419f7d00b9e1c2 (plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
220
221
222
223
224
225
226
227
228
229
230
231
232
233
234
235
236
237
238
239
240
241
242
243
244
245
246
247
248
249
250
251
252
253
254
255
256
257
258
259
260
261
262
263
264
265
266
267
268
269
270
271
272
273
274
275
276
277
278
279
280
281
282
283
// SPDX-License-Identifier: GPL-2.0-or-later
/*
 * Copyright (C) 2015 Masahiro Yamada <yamada.masahiro@socionext.com>
 */

#include <linux/io.h>
#include <linux/log2.h>
#include <linux/module.h>
#include <linux/of.h>
#include <linux/of_address.h>
#include <linux/of_platform.h>
#include <linux/platform_device.h>

/* System Bus Controller registers */
#define UNIPHIER_SBC_BASE	0x100	/* base address of bank0 space */
#define    UNIPHIER_SBC_BASE_BE		BIT(0)	/* bank_enable */
#define UNIPHIER_SBC_CTRL0	0x200	/* timing parameter 0 of bank0 */
#define UNIPHIER_SBC_CTRL1	0x204	/* timing parameter 1 of bank0 */
#define UNIPHIER_SBC_CTRL2	0x208	/* timing parameter 2 of bank0 */
#define UNIPHIER_SBC_CTRL3	0x20c	/* timing parameter 3 of bank0 */
#define UNIPHIER_SBC_CTRL4	0x300	/* timing parameter 4 of bank0 */

#define UNIPHIER_SBC_STRIDE	0x10	/* register stride to next bank */
#define UNIPHIER_SBC_NR_BANKS	8	/* number of banks (chip select) */
#define UNIPHIER_SBC_BASE_DUMMY	0xffffffff	/* data to squash bank 0, 1 */

struct uniphier_system_bus_bank {
	u32 base;
	u32 end;
};

struct uniphier_system_bus_priv {
	struct device *dev;
	void __iomem *membase;
	struct uniphier_system_bus_bank bank[UNIPHIER_SBC_NR_BANKS];
};

static int uniphier_system_bus_add_bank(struct uniphier_system_bus_priv *priv,
					int bank, u32 addr, u64 paddr, u32 size)
{
	u64 end, mask;

	dev_dbg(priv->dev,
		"range found: bank = %d, addr = %08x, paddr = %08llx, size = %08x\n",
		bank, addr, paddr, size);

	if (bank >= ARRAY_SIZE(priv->bank)) {
		dev_err(priv->dev, "unsupported bank number %d\n", bank);
		return -EINVAL;
	}

	if (priv->bank[bank].base || priv->bank[bank].end) {
		dev_err(priv->dev,
			"range for bank %d has already been specified\n", bank);
		return -EINVAL;
	}

	if (paddr > U32_MAX) {
		dev_err(priv->dev, "base address %llx is too high\n", paddr);
		return -EINVAL;
	}

	end = paddr + size;

	if (addr > paddr) {
		dev_err(priv->dev,
			"base %08x cannot be mapped to %08llx of parent\n",
			addr, paddr);
		return -EINVAL;
	}
	paddr -= addr;

	paddr = round_down(paddr, 0x00020000);
	end = round_up(end, 0x00020000);

	if (end > U32_MAX) {
		dev_err(priv->dev, "end address %08llx is too high\n", end);
		return -EINVAL;
	}
	mask = paddr ^ (end - 1);
	mask = roundup_pow_of_two(mask);

	paddr = round_down(paddr, mask);
	end = round_up(end, mask);

	priv->bank[bank].base = paddr;
	priv->bank[bank].end = end;

	dev_dbg(priv->dev, "range added: bank = %d, addr = %08x, end = %08x\n",
		bank, priv->bank[bank].base, priv->bank[bank].end);

	return 0;
}

static int uniphier_system_bus_check_overlap(
				const struct uniphier_system_bus_priv *priv)
{
	int i, j;

	for (i = 0; i < ARRAY_SIZE(priv->bank); i++) {
		for (j = i + 1; j < ARRAY_SIZE(priv->bank); j++) {
			if (priv->bank[i].end > priv->bank[j].base &&
			    priv->bank[i].base < priv->bank[j].end) {
				dev_err(priv->dev,
					"region overlap between bank%d and bank%d\n",
					i, j);
				return -EINVAL;
			}
		}
	}

	return 0;
}

static void uniphier_system_bus_check_boot_swap(
					struct uniphier_system_bus_priv *priv)
{
	void __iomem *base_reg = priv->membase + UNIPHIER_SBC_BASE;
	int is_swapped;

	is_swapped = !(readl(base_reg) & UNIPHIER_SBC_BASE_BE);

	dev_dbg(priv->dev, "Boot Swap: %s\n", is_swapped ? "on" : "off");

	/*
	 * If BOOT_SWAP was asserted on power-on-reset, the CS0 and CS1 are
	 * swapped.  In this case, bank0 and bank1 should be swapped as well.
	 */
	if (is_swapped)
		swap(priv->bank[0], priv->bank[1]);
}

static void uniphier_system_bus_set_reg(
				const struct uniphier_system_bus_priv *priv)
{
	void __iomem *base_reg = priv->membase + UNIPHIER_SBC_BASE;
	u32 base, end, mask, val;
	int i;

	for (i = 0; i < ARRAY_SIZE(priv->bank); i++) {
		base = priv->bank[i].base;
		end = priv->bank[i].end;

		if (base == end) {
			/*
			 * If SBC_BASE0 or SBC_BASE1 is set to zero, the access
			 * to anywhere in the system bus space is routed to
			 * bank 0 (if boot swap if off) or bank 1 (if boot swap
			 * if on).  It means that CPUs cannot get access to
			 * bank 2 or later.  In other words, bank 0/1 cannot
			 * be disabled even if its bank_enable bits is cleared.
			 * This seems odd, but it is how this hardware goes.
			 * As a workaround, dummy data (0xffffffff) should be
			 * set when the bank 0/1 is unused.  As for bank 2 and
			 * later, they can be simply disable by clearing the
			 * bank_enable bit.
			 */
			if (i < 2)
				val = UNIPHIER_SBC_BASE_DUMMY;
			else
				val = 0;
		} else {
			mask = base ^ (end - 1);

			val = base & 0xfffe0000;
			val |= (~mask >> 16) & 0xfffe;
			val |= UNIPHIER_SBC_BASE_BE;
		}
		dev_dbg(priv->dev, "SBC_BASE[%d] = 0x%08x\n", i, val);

		writel(val, base_reg + UNIPHIER_SBC_STRIDE * i);
	}
}

static int uniphier_system_bus_probe(struct platform_device *pdev)
{
	struct device *dev = &pdev->dev;
	struct uniphier_system_bus_priv *priv;
	const __be32 *ranges;
	u32 cells, addr, size;
	u64 paddr;
	int pna, bank, rlen, rone, ret;

	priv = devm_kzalloc(dev, sizeof(*priv), GFP_KERNEL);
	if (!priv)
		return -ENOMEM;

	priv->membase = devm_platform_ioremap_resource(pdev, 0);
	if (IS_ERR(priv->membase))
		return PTR_ERR(priv->membase);

	priv->dev = dev;

	pna = of_n_addr_cells(dev->of_node);

	ret = of_property_read_u32(dev->of_node, "#address-cells", &cells);
	if (ret) {
		dev_err(dev, "failed to get #address-cells\n");
		return ret;
	}
	if (cells != 2) {
		dev_err(dev, "#address-cells must be 2\n");
		return -EINVAL;
	}

	ret = of_property_read_u32(dev->of_node, "#size-cells", &cells);
	if (ret) {
		dev_err(dev, "failed to get #size-cells\n");
		return ret;
	}
	if (cells != 1) {
		dev_err(dev, "#size-cells must be 1\n");
		return -EINVAL;
	}

	ranges = of_get_property(dev->of_node, "ranges", &rlen);
	if (!ranges) {
		dev_err(dev, "failed to get ranges property\n");
		return -ENOENT;
	}

	rlen /= sizeof(*ranges);
	rone = pna + 2;

	for (; rlen >= rone; rlen -= rone) {
		bank = be32_to_cpup(ranges++);
		addr = be32_to_cpup(ranges++);
		paddr = of_translate_address(dev->of_node, ranges);
		if (paddr == OF_BAD_ADDR)
			return -EINVAL;
		ranges += pna;
		size = be32_to_cpup(ranges++);

		ret = uniphier_system_bus_add_bank(priv, bank, addr,
						   paddr, size);
		if (ret)
			return ret;
	}

	ret = uniphier_system_bus_check_overlap(priv);
	if (ret)
		return ret;

	uniphier_system_bus_check_boot_swap(priv);

	uniphier_system_bus_set_reg(priv);

	platform_set_drvdata(pdev, priv);

	/* Now, the bus is configured.  Populate platform_devices below it */
	return of_platform_default_populate(dev->of_node, NULL, dev);
}

static int __maybe_unused uniphier_system_bus_resume(struct device *dev)
{
	uniphier_system_bus_set_reg(dev_get_drvdata(dev));

	return 0;
}

static const struct dev_pm_ops uniphier_system_bus_pm_ops = {
	SET_SYSTEM_SLEEP_PM_OPS(NULL, uniphier_system_bus_resume)
};

static const struct of_device_id uniphier_system_bus_match[] = {
	{ .compatible = "socionext,uniphier-system-bus" },
	{ /* sentinel */ }
};
MODULE_DEVICE_TABLE(of, uniphier_system_bus_match);

static struct platform_driver uniphier_system_bus_driver = {
	.probe		= uniphier_system_bus_probe,
	.driver = {
		.name	= "uniphier-system-bus",
		.of_match_table = uniphier_system_bus_match,
		.pm = &uniphier_system_bus_pm_ops,
	},
};
module_platform_driver(uniphier_system_bus_driver);

MODULE_AUTHOR("Masahiro Yamada <yamada.masahiro@socionext.com>");
MODULE_DESCRIPTION("UniPhier System Bus driver");
MODULE_LICENSE("GPL");