diff options
Diffstat (limited to 'Documentation/devicetree/bindings/mmc/sdhci-atmel.txt')
-rw-r--r-- | Documentation/devicetree/bindings/mmc/sdhci-atmel.txt | 18 |
1 files changed, 15 insertions, 3 deletions
diff --git a/Documentation/devicetree/bindings/mmc/sdhci-atmel.txt b/Documentation/devicetree/bindings/mmc/sdhci-atmel.txt index 1b662d7171a0..69edfd4d3922 100644 --- a/Documentation/devicetree/bindings/mmc/sdhci-atmel.txt +++ b/Documentation/devicetree/bindings/mmc/sdhci-atmel.txt @@ -5,17 +5,29 @@ Documentation/devicetree/bindings/mmc/mmc.txt and the properties used by the sdhci-of-at91 driver. Required properties: -- compatible: Must be "atmel,sama5d2-sdhci". +- compatible: Must be "atmel,sama5d2-sdhci" or "microchip,sam9x60-sdhci". - clocks: Phandlers to the clocks. -- clock-names: Must be "hclock", "multclk", "baseclk"; +- clock-names: Must be "hclock", "multclk", "baseclk" for + "atmel,sama5d2-sdhci". + Must be "hclock", "multclk" for "microchip,sam9x60-sdhci". +Optional properties: +- assigned-clocks: The same with "multclk". +- assigned-clock-rates The rate of "multclk" in order to not rely on the + gck configuration set by previous components. +- microchip,sdcal-inverted: when present, polarity on the SDCAL SoC pin is + inverted. The default polarity for this signal is described in the datasheet. + For instance on SAMA5D2, the pin is usually tied to the GND with a resistor + and a capacitor (see "SDMMC I/O Calibration" chapter). Example: -sdmmc0: sdio-host@a0000000 { +mmc0: sdio-host@a0000000 { compatible = "atmel,sama5d2-sdhci"; reg = <0xa0000000 0x300>; interrupts = <31 IRQ_TYPE_LEVEL_HIGH 0>; clocks = <&sdmmc0_hclk>, <&sdmmc0_gclk>, <&main>; clock-names = "hclock", "multclk", "baseclk"; + assigned-clocks = <&sdmmc0_gclk>; + assigned-clock-rates = <480000000>; }; |