aboutsummaryrefslogtreecommitdiff
path: root/Documentation/input
diff options
context:
space:
mode:
Diffstat (limited to 'Documentation/input')
-rw-r--r--Documentation/input/atarikbd.txt4
-rw-r--r--Documentation/input/xpad.txt6
2 files changed, 5 insertions, 5 deletions
diff --git a/Documentation/input/atarikbd.txt b/Documentation/input/atarikbd.txt
index 668f4d0d97d..ab050621e20 100644
--- a/Documentation/input/atarikbd.txt
+++ b/Documentation/input/atarikbd.txt
@@ -179,9 +179,9 @@ reporting mode for joystick 1, with both buttons being logically assigned to
the mouse. After any joystick command, the ikbd assumes that joysticks are
connected to both Joystick0 and Joystick1. Any mouse command (except MOUSE
DISABLE) then causes port 0 to again be scanned as if it were a mouse, and
-both buttons are logically connected to it. If a mouse diable command is
+both buttons are logically connected to it. If a mouse disable command is
received while port 0 is presumed to be a mouse, the button is logically
-assigned to Joystick1 ( until the mouse is reenabled by another mouse command).
+assigned to Joystick1 (until the mouse is reenabled by another mouse command).
9. ikbd Command Set
diff --git a/Documentation/input/xpad.txt b/Documentation/input/xpad.txt
index 5427bdf225e..aae0d404c56 100644
--- a/Documentation/input/xpad.txt
+++ b/Documentation/input/xpad.txt
@@ -65,15 +65,15 @@ of buttons, see section 0.3 - Unknown Controllers
I've tested this with Stepmania, and it works quite well.
-0.3 Unkown Controllers
+0.3 Unknown Controllers
----------------------
-If you have an unkown xbox controller, it should work just fine with
+If you have an unknown xbox controller, it should work just fine with
the default settings.
HOWEVER if you have an unknown dance pad not listed below, it will not
work UNLESS you set "dpad_to_buttons" to 1 in the module configuration.
-PLEASE if you have an unkown controller, email Dom <binary1230@yahoo.com> with
+PLEASE, if you have an unknown controller, email Dom <binary1230@yahoo.com> with
a dump from /proc/bus/usb and a description of the pad (manufacturer, country,
whether it is a dance pad or normal controller) so that we can add your pad
to the list of supported devices, ensuring that it will work out of the