kgdb: core changes to support kdb

These are the minimum changes to the kgdb core in order to enable an
API to connect a new front end (kdb) to the debug core.

This patch introduces the dbg_kdb_mode variable controls where the
user level I/O is routed.  It will be routed to the gdbstub (kgdb) or
to the kdb front end which is a simple shell available over the kgdboc
connection.

You can switch back and forth between kdb or the gdb stub mode of
operation dynamically.  From gdb stub mode you can blindly type
"$3#33", or from the kdb mode you can enter "kgdb" to switch to the
gdb stub.

The logic in the debug core depends on kdb to look for the typical gdb
connection sequences and return immediately with KGDB_PASS_EVENT if a
gdb serial command sequence is detected.  That should allow a
reasonably seamless transition between kdb -> gdb without leaving the
kernel exception state.  The two gdb serial queries that kdb is
responsible for detecting are the "?" and "qSupported" packets.

CC: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Jason Wessel <jason.wessel@windriver.com>
Acked-by: Martin Hicks <mort@sgi.com>

1 files changed, 5 insertions, 0 deletions

diff --git a/arch/x86/kernel/kgdb.c b/arch/x86/kernel/kgdb.c
index b2258ca9100..f95a2c0b915 100644
--- a/arch/x86/kernel/kgdb.c
+++ b/arch/x86/kernel/kgdb.c
@@ -690,6 +690,11 @@ unsigned long kgdb_arch_pc(int exception, struct pt_regs *regs)
 	return instruction_pointer(regs);
 }
 
+void kgdb_arch_set_pc(struct pt_regs *regs, unsigned long ip)
+{
+	regs->ip = ip;
+}
+
 struct kgdb_arch arch_kgdb_ops = {
 	/* Breakpoint instruction: */
 	.gdb_bpt_instr		= { 0xcc },