diff options
Diffstat (limited to 'arch/blackfin/mach-bf533/include')
| -rw-r--r-- | arch/blackfin/mach-bf533/include/mach/anomaly.h | 49 | ||||
| -rw-r--r-- | arch/blackfin/mach-bf533/include/mach/bf533.h | 12 | ||||
| -rw-r--r-- | arch/blackfin/mach-bf533/include/mach/bfin_serial_5xx.h | 8 |
3 files changed, 36 insertions, 33 deletions
diff --git a/arch/blackfin/mach-bf533/include/mach/anomaly.h b/arch/blackfin/mach-bf533/include/mach/anomaly.h index 8f7ea112fd3..f544fc56959 100644 --- a/arch/blackfin/mach-bf533/include/mach/anomaly.h +++ b/arch/blackfin/mach-bf533/include/mach/anomaly.h @@ -7,7 +7,7 @@ */ /* This file shoule be up to date with: - * - Revision C, 02/08/2008; ADSP-BF531/BF532/BF533 Blackfin Processor Anomaly List + * - Revision D, 06/18/2008; ADSP-BF531/BF532/BF533 Blackfin Processor Anomaly List */ #ifndef _MACH_ANOMALY_H_ @@ -97,11 +97,11 @@ /* UART STB Bit Incorrectly Affects Receiver Setting */ #define ANOMALY_05000231 (__SILICON_REVISION__ < 5) /* PPI_FS3 Is Not Driven in 2 or 3 Internal Frame Sync Transmit Modes */ -#define ANOMALY_05000233 (__SILICON_REVISION__ < 4) +#define ANOMALY_05000233 (__SILICON_REVISION__ < 6) /* Incorrect Revision Number in DSPID Register */ #define ANOMALY_05000234 (__SILICON_REVISION__ == 4) /* DF Bit in PLL_CTL Register Does Not Respond to Hardware Reset */ -#define ANOMALY_05000242 (__SILICON_REVISION__ < 4) +#define ANOMALY_05000242 (__SILICON_REVISION__ < 5) /* If I-Cache Is On, CSYNC/SSYNC/IDLE Around Change of Control Causes Failures */ #define ANOMALY_05000244 (__SILICON_REVISION__ < 5) /* Spurious Hardware Error from an Access in the Shadow of a Conditional Branch */ @@ -131,7 +131,7 @@ /* CSYNC/SSYNC/IDLE Causes Infinite Stall in Penultimate Instruction in Hardware Loop */ #define ANOMALY_05000264 (__SILICON_REVISION__ < 5) /* Sensitivity To Noise with Slow Input Edge Rates on External SPORT TX and RX Clocks */ -#define ANOMALY_05000265 (__SILICON_REVISION__ < 5) +#define ANOMALY_05000265 (1) /* High I/O Activity Causes Output Voltage of Internal Voltage Regulator (Vddint) to Increase */ #define ANOMALY_05000269 (__SILICON_REVISION__ < 5) /* High I/O Activity Causes Output Voltage of Internal Voltage Regulator (Vddint) to Decrease */ @@ -141,56 +141,59 @@ /* Certain Data Cache Writethrough Modes Fail for Vddint <= 0.9V */ #define ANOMALY_05000272 (1) /* Writes to Synchronous SDRAM Memory May Be Lost */ -#define ANOMALY_05000273 (1) +#define ANOMALY_05000273 (__SILICON_REVISION__ < 6) /* Timing Requirements Change for External Frame Sync PPI Modes with Non-Zero PPI_DELAY */ #define ANOMALY_05000276 (1) /* Writes to an I/O Data Register One SCLK Cycle after an Edge Is Detected May Clear Interrupt */ -#define ANOMALY_05000277 (1) +#define ANOMALY_05000277 (__SILICON_REVISION__ < 6) /* Disabling Peripherals with DMA Running May Cause DMA System Instability */ -#define ANOMALY_05000278 (1) +#define ANOMALY_05000278 (__SILICON_REVISION__ < 6) /* False Hardware Error Exception When ISR Context Is Not Restored */ -#define ANOMALY_05000281 (1) +#define ANOMALY_05000281 (__SILICON_REVISION__ < 6) /* Memory DMA Corruption with 32-Bit Data and Traffic Control */ -#define ANOMALY_05000282 (1) +#define ANOMALY_05000282 (__SILICON_REVISION__ < 6) /* System MMR Write Is Stalled Indefinitely When Killed in a Particular Stage */ -#define ANOMALY_05000283 (1) +#define ANOMALY_05000283 (__SILICON_REVISION__ < 6) /* SPORTs May Receive Bad Data If FIFOs Fill Up */ -#define ANOMALY_05000288 (1) +#define ANOMALY_05000288 (__SILICON_REVISION__ < 6) /* Memory-To-Memory DMA Source/Destination Descriptors Must Be in Same Memory Space */ -#define ANOMALY_05000301 (1) +#define ANOMALY_05000301 (__SILICON_REVISION__ < 6) /* SSYNCs After Writes To DMA MMR Registers May Not Be Handled Correctly */ #define ANOMALY_05000302 (__SILICON_REVISION__ < 5) /* New Feature: Additional Hysteresis on SPORT Input Pins (Not Available On Older Silicon) */ #define ANOMALY_05000305 (__SILICON_REVISION__ < 5) /* New Feature: Additional PPI Frame Sync Sampling Options (Not Available On Older Silicon) */ #define ANOMALY_05000306 (__SILICON_REVISION__ < 5) +/* SCKELOW Bit Does Not Maintain State Through Hibernate */ +#define ANOMALY_05000307 (1) /* False Hardware Errors Caused by Fetches at the Boundary of Reserved Memory */ #define ANOMALY_05000310 (1) /* Erroneous Flag (GPIO) Pin Operations under Specific Sequences */ -#define ANOMALY_05000311 (1) +#define ANOMALY_05000311 (__SILICON_REVISION__ < 6) /* Errors When SSYNC, CSYNC, or Loads to LT, LB and LC Registers Are Interrupted */ -#define ANOMALY_05000312 (1) +#define ANOMALY_05000312 (__SILICON_REVISION__ < 6) /* PPI Is Level-Sensitive on First Transfer */ -#define ANOMALY_05000313 (1) +#define ANOMALY_05000313 (__SILICON_REVISION__ < 6) /* Killed System MMR Write Completes Erroneously On Next System MMR Access */ -#define ANOMALY_05000315 (1) +#define ANOMALY_05000315 (__SILICON_REVISION__ < 6) /* Internal Voltage Regulator Values of 1.05V, 1.10V and 1.15V Not Allowed for LQFP Packages */ -#define ANOMALY_05000319 (ANOMALY_BF531 || ANOMALY_BF532) +#define ANOMALY_05000319 ((ANOMALY_BF531 || ANOMALY_BF532) && __SILICON_REVISION__ < 6) /* Serial Port (SPORT) Multichannel Transmit Failure when Channel 0 Is Disabled */ -#define ANOMALY_05000357 (1) +#define ANOMALY_05000357 (__SILICON_REVISION__ < 6) /* UART Break Signal Issues */ #define ANOMALY_05000363 (__SILICON_REVISION__ < 5) /* PPI Underflow Error Goes Undetected in ITU-R 656 Mode */ #define ANOMALY_05000366 (1) /* Possible RETS Register Corruption when Subroutine Is under 5 Cycles in Duration */ -#define ANOMALY_05000371 (1) +#define ANOMALY_05000371 (__SILICON_REVISION__ < 6) /* PPI Does Not Start Properly In Specific Mode */ -#define ANOMALY_05000400 (__SILICON_REVISION__ >= 5) +#define ANOMALY_05000400 (__SILICON_REVISION__ == 5) /* SSYNC Stalls Processor when Executed from Non-Cacheable Memory */ -#define ANOMALY_05000402 (__SILICON_REVISION__ >= 5) +#define ANOMALY_05000402 (__SILICON_REVISION__ == 5) /* Level-Sensitive External GPIO Wakeups May Cause Indefinite Stall */ #define ANOMALY_05000403 (1) - +/* Speculative Fetches Can Cause Undesired External FIFO Operations */ +#define ANOMALY_05000416 (1) /* These anomalies have been "phased" out of analog.com anomaly sheets and are * here to show running on older silicon just isn't feasible. @@ -268,5 +271,7 @@ /* Anomalies that don't exist on this proc */ #define ANOMALY_05000266 (0) #define ANOMALY_05000323 (0) +#define ANOMALY_05000353 (1) +#define ANOMALY_05000386 (1) #endif diff --git a/arch/blackfin/mach-bf533/include/mach/bf533.h b/arch/blackfin/mach-bf533/include/mach/bf533.h index 12a41693199..dfc8c1ad2d7 100644 --- a/arch/blackfin/mach-bf533/include/mach/bf533.h +++ b/arch/blackfin/mach-bf533/include/mach/bf533.h @@ -30,8 +30,6 @@ #ifndef __MACH_BF533_H__ #define __MACH_BF533_H__ -#define SUPPORTED_REVID 2 - #define OFFSET_(x) ((x) & 0x0000FFFF) /*some misc defines*/ @@ -143,19 +141,19 @@ #ifdef CONFIG_BF533 #define CPU "BF533" -#define CPUID 0x027a5000 +#define CPUID 0x27a5 #endif #ifdef CONFIG_BF532 #define CPU "BF532" -#define CPUID 0x0275A000 +#define CPUID 0x275A #endif #ifdef CONFIG_BF531 #define CPU "BF531" -#define CPUID 0x027a5000 +#define CPUID 0x27a5 #endif + #ifndef CPU -#define CPU "UNKNOWN" -#define CPUID 0x0 +#error Unknown CPU type - This kernel doesn't seem to be configured properly #endif #endif /* __MACH_BF533_H__ */ diff --git a/arch/blackfin/mach-bf533/include/mach/bfin_serial_5xx.h b/arch/blackfin/mach-bf533/include/mach/bfin_serial_5xx.h index ebf592b59aa..f3d9e495230 100644 --- a/arch/blackfin/mach-bf533/include/mach/bfin_serial_5xx.h +++ b/arch/blackfin/mach-bf533/include/mach/bfin_serial_5xx.h @@ -69,6 +69,8 @@ # endif #endif +#define BFIN_UART_TX_FIFO_SIZE 2 + struct bfin_serial_port { struct uart_port port; unsigned int old_status; @@ -83,7 +85,7 @@ struct bfin_serial_port { unsigned int rx_dma_channel; struct work_struct tx_dma_workqueue; #else -# if ANOMALY_05000230 +# if ANOMALY_05000363 unsigned int anomaly_threshold; # endif #endif @@ -111,7 +113,6 @@ static inline void UART_CLEAR_LSR(struct bfin_serial_port *uart) bfin_write16(uart->port.membase + OFFSET_LSR, -1); } -struct bfin_serial_port bfin_serial_ports[BFIN_UART_NR_PORTS]; struct bfin_serial_res { unsigned long uart_base_addr; int uart_irq; @@ -142,7 +143,6 @@ struct bfin_serial_res bfin_serial_resource[] = { #define DRIVER_NAME "bfin-uart" -int nr_ports = BFIN_UART_NR_PORTS; static void bfin_serial_hw_init(struct bfin_serial_port *uart) { @@ -158,7 +158,7 @@ static void bfin_serial_hw_init(struct bfin_serial_port *uart) } if (uart->rts_pin >= 0) { gpio_request(uart->rts_pin, DRIVER_NAME); - gpio_direction_input(uart->rts_pin, 0); + gpio_direction_output(uart->rts_pin, 0); } #endif } |