aboutsummaryrefslogtreecommitdiff
path: root/board
AgeCommit message (Expand)Author
2011-11-25Add support for AP9500 in same binary as for U8500Paer-Olof Haakansson
2011-11-15u8500: Fix of coverity errors in dump handlerPaer-Olof Haakansson
2011-10-04u8500: Dump after SW reset at kernel crashPer Fransson
2011-10-04u8500: Create dump ELF based on 'memargs'Per Fransson
2011-09-29u5500:Read cspsa bit to check modem typeaurla000
2011-09-24u-boot:u5500:Fix for the touch screen issueSesahgiri.Holi
2011-09-20u-boot:u5500:Add keypad support in u-boot.Sesahgiri.Holi
2011-09-19u5500:Avoid hangs in modem and itp loadingNaveen Kumar Gaddipati
2011-08-09u5500:Dynamic detection of bootable MMCNaveen Kumar Gaddipati
2011-08-08u8500: Add commands to read and write into ab8500Rikard Olsson
2011-07-18u5500: Add uart0 rx interrupts support for 5500v2Naveen Kumar Gaddipati
2011-07-11U8500: HATS: Add uart mode support in hats commandOlivier ARNAUD
2011-06-30u5500: add support for prcmu_read/write functionsMichael Brandt
2011-05-23U5500: Add modem and itp loadingMikael Larsson
2011-05-18u8500: Add commands to boot HATS or AndroidOlivier ARNAUD
2011-05-18u5500:mmc:Add partition to support LTP tests on EMMCNaveen Kumar Gaddipati
2011-05-06U8500: Add support for 6 Gbit and 8 Gbit memoryMagnus Persson
2011-04-21U8500: Add support for 24/32 bpp framebufferDan Johansson
2011-04-13U8500: Fix errors in MCDE L1 macrosDan Johansson
2011-04-11Add U5500 board and platform supportHans Holmberg
2011-03-31U8500: Save and restore PRCMU registers for crashdumpPer Fransson
2011-03-30U8500: Let kexec override crash_reboot variablePer Fransson
2011-03-30u8500: Build warning fixesRobert Rosengren
2011-03-28U8500: MMC: set base addr in board code and try alternativeMichael Brandt
2011-03-18U8500: Rearrange the printouts for ITP, MCDE and MMC devicesPeter Nessrup
2011-03-16U8500: Reinitialize SDMMC clock in case of crashOla Rylow
2011-03-15U8500: move board from st to st-ericssonMichael Brandt
2011-03-10U8500: i2c clean-upMichael Brandt
2011-03-09u8500: Use PLLDDR for MCDE/HDMIPer Persson
2011-03-08U8500: Use default value for SDMMC_1V8_3V_SELOla Rylow
2011-02-23u8500: Adding cmd_ prefix to mmc_utilsRobert Rosengren
2011-02-23U8500: Move MMC code into driversRobert Rosengren
2011-02-16U8500: Set SD bus width to 4-bitOla Rylow
2011-02-15U8500: Fix warnings in dump codePer Fransson
2011-02-14U8500: Make dump-to-mmc and linux reboot configurablePer Fransson
2011-02-11U8500: Display driver: Fix for HDMI not workingJimmy Rubin
2011-02-08U8500: Display driver: Only activate required clocks for displayTorbjorn Svensson
2011-01-31U8500: Kick the Cortex watchdog when dumpingPer Fransson
2011-01-28U8500: Change display reset for HREFP 2.0 V60 and laterMichael Brandt
2011-01-20U8500: Lower cut-off voltage threshold in AB8500Johan Palsson
2011-01-20U8500: Display driver: Remove enable interrupts for mcdeTorbjorn Svensson
2011-01-18U8500: Add support for HREFP 2.0 V60 and laterMichael Brandt
2011-01-18U8500: Generic display driverTorbjorn Svensson
2010-12-15Removal of executable permissionRobert Rosengren
2010-12-15U8500: Move itp and cspsa into SoC directoryRobert Rosengren
2010-12-13U8500: Changes to use a bmp file as splash imageTorbjorn Svensson
2010-12-08db8500: New GPIO driver and config, from Linux kernelJoakim Axelsson
2010-12-08db8500: Move all clock code from board to SoCJoakim Axelsson
2010-12-08db8500: Move cpu identifying function to SoC codeJoakim Axelsson
2010-12-08db8500: Split arch_cpu code from boardJoakim Axelsson
generated by cgit v1.2.3 (git 2.25.1) at 2024-04-27 04:50:16 +0000