aboutsummaryrefslogtreecommitdiff
path: root/doc/README.sbc8560
blob: 52592e3f4161d8f4bec6eb51e104cbd7908d7ffa (plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
The port was tested on Wind River System Sbc8560 board <www.windriver.com>.
U-Boot was installed on the flash memory of the CPU card (no the SODIMM).

NOTE: Please configure uboot compile to the proper PCI frequency and
setup the appropriate DIP switch settings.

SBC8560 board:

Make sure boards switches are set to their appropriate conditions.
Refer to the Engineering Reference Guide ERG-00300-002. Of particular
importance are: 1)Tthe settings for JP4 (JP4 1-3 and 2-4), which
select the on-board FLASH device (Intel 28F128Jx); 2) The settings
for the Clock SW9 (33 MHz or 66 MHz).

	Note:	SW9 Settings: 66 MHz
		4:1 ratio CCB clocks:SYSCLK
		3:1 ration e500 Core:CCB
		pos1 - on, pos2 - on, pos3 - off, pos4 - on, pos5 - off, pos6 - on
	Note:	SW9 Settings: 33 MHz
		8:1 ratio CCB clocks:SYSCLK
		3:1 ration e500 Core:CCB
		pos1 - on, pos2 - on, pos3 - on, pos4 - off, pos5 - off, pos6 - on


Flashing the FLASH device with the "Wind River ICE":

1) Properly connect and configure the Wind River ICE to the
   target JTAG port. This includes running the SBC8560 register script.
   Make sure target memory can be read and written.

2) Build the u-boot image:
	make distclean
	make SBC8560_66_config or SBC8560_33_config
	make CROSS_COMPILE=.../ELDK3.0/ppc_8xx-/ all

   Note: reference is made to the ELDK3.0 compiler but any 85xx cross-compiler
	 should suffice.

3) Convert the uboot (.elf) file to a uboot.bin file (using visionClick converter).
   The bin file should be converted from fffc0000 to ffffffff

4) Setup the Flash Utility (tools menu) for:

   Determine the clock speed of the PCI bus and set SW9 accordingly
	Note: the speed of the PCI bus defaults to the slowest PCI card
   PlayBack the "default" register file for the SBC8560
   Select the uboot.bin file with zero bias
   Select the initialize Target prior to programming
   Select the V28F640Jx (8192 x 8) 1 device FLASH Algorithm
   Select the erase base address from FFFC0000 to FFFFFFFF
   Select the start address from 0 with size of 4000

5) Erase and Program