| metadata: |
| name: software-raid1 |
| format: "Manual Test Definition 1.0" |
| description: "Use Linux utility mdadm to create, rebuild and delete |
| software RAID1. RAID1 consists of data mirroring, without |
| parity or striping." |
| maintainer: |
| - chase.qi@linaro.org |
| os: |
| - debian |
| - ubuntu |
| - centos |
| - fedora |
| scope: |
| - functional |
| devices: |
| - d02 |
| - d03 |
| - d05 |
| - overdrive |
| - moonshot |
| - thunderX |
| environment: |
| - manual-test |
| |
| run: |
| steps: |
| - Install OS on the SUT(system under test) and make sure it boots. |
| - Power off the SUT and install three extra hard drives(use sd(b|c|d) |
| here). The three hard drives shoud have the same mode, at least the |
| same capacity. |
| - Boot to OS and make sure mdadm utility installed. |
| - Create 'Linux RAID auto' partition on each of the three hard drives |
| by running the following steps. |
| - 1) "fdisk /dev/sdx" |
| - 2) Delete all existing partitions with fdisk command "d" |
| - 3) Create Linux raid auto partition with fdisk commands |
| "n -> p -> 1 -> enter -> enter -> t -> fd -> w" |
| - Run the following steps to test RAID1. |
| - 1) "mdadm --create /dev/md0 --level=mirror --raid-devices=2 /dev/sd[b-c]1" |
| - 2) Monitor '/proc/mdstat' to check if md0 created and running. |
| - 3) "mkfs.ext4 /dev/md0" |
| - 4) "mount /dev/md0 /mnt" |
| - 5) "echo 'RAID1 test' > /mnt raid1-test.txt" |
| - 6) Intentionally set faulty partition with command |
| "mdadm --manage --set-faulty /dev/md0 /dev/sdc1" |
| - 7) Execute "mdadm --detail /dev/md0" and check if RAID array shown as |
| 'degraded' and sdc1 shown as 'faulty spare'. |
| - 8) Execute "mdadm --manage /dev/md0 -r /dev/sdc1" to remove sdc1. |
| - 9) Verify that '/mnt/raid1-test.txt' is not damaged. |
| - 10) Execute "mdadm --manage /dev/md0 -a /dev/sdd1" to add sdd1. |
| - 11) Monitor the output of "mdadm --detail /dev/md0" and make sure |
| that md0 'rebuilding' can be finished. |
| - Remove the md0 by running the following steps. |
| - 1) "umount /dev/md0" |
| - 2) "mdadm --stop /dev/md0" |
| - 3) "mdadm --remove /dev/md0" |
| - 4) "mdadm --zero-superblock /dev/sdb1 /dev/sdc1 /dev/sdd1" |
| |
| expected: |
| - RAID1 array creating, deleting and rebuilding are successful. |
| - When one disk of RAID1 array damaged or removed, no data loss. |
| - When faulty disk replaced with a new one, RAID1 array can be rebuilt. |