ath9k: Cleanup beacon logic
* The beaconing status routine is not required, since in
multi-VIF cases the HW beacon parameters should not be
re-configured.
* Remove SC_OP_TSF_RESET - when a beaconing interface comes
up the first time, the TSF has to be reset.
* Simplify ath9k_allow_beacon_config().
* Handle setting/clearing the SWBA interrupt properly.
* Remove the TSF mangling in IBSS mode, it is not required.
* General code cleanup.
Signed-off-by: Sujith Manoharan <c_manoha@qca.qualcomm.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/ath/ath9k/main.c b/drivers/net/wireless/ath/ath9k/main.c
index 2a155ce..e411189 100644
--- a/drivers/net/wireless/ath/ath9k/main.c
+++ b/drivers/net/wireless/ath/ath9k/main.c
@@ -236,7 +236,7 @@
if (!test_bit(SC_OP_BEACONS, &sc->sc_flags))
goto work;
- ath_set_beacon(sc);
+ ath9k_set_beacon(sc);
if (ah->opmode == NL80211_IFTYPE_STATION &&
test_bit(SC_OP_PRIM_STA_VIF, &sc->sc_flags)) {
@@ -1533,24 +1533,10 @@
}
}
- /*
- * In case of AP mode, the HW TSF has to be reset
- * when the beacon interval changes.
- */
- if ((changed & BSS_CHANGED_BEACON_INT) &&
- (vif->type == NL80211_IFTYPE_AP))
- set_bit(SC_OP_TSF_RESET, &sc->sc_flags);
-
- /* Configure beaconing (AP, IBSS, MESH) */
- if (ath9k_uses_beacons(vif->type) &&
- ((changed & BSS_CHANGED_BEACON) ||
- (changed & BSS_CHANGED_BEACON_ENABLED) ||
- (changed & BSS_CHANGED_BEACON_INT))) {
- ath9k_set_beaconing_status(sc, false);
- if (!bss_conf->enable_beacon)
- avp->is_bslot_active = false;
- ath_beacon_config(sc, vif);
- ath9k_set_beaconing_status(sc, true);
+ if ((changed & BSS_CHANGED_BEACON_ENABLED) ||
+ (changed & BSS_CHANGED_BEACON_INT)) {
+ if (ath9k_allow_beacon_config(sc, vif))
+ ath9k_beacon_config(sc, vif, changed);
}
if (changed & BSS_CHANGED_ERP_SLOT) {