Bluetooth: hci_uart: Add support Broadcom address configuration
When using vendor detection, this adds support for the Broadcom
specific address configuration command.
Signed-off-by: Marcel Holtmann <marcel@holtmann.org>
Signed-off-by: Johan Hedberg <johan.hedberg@intel.com>
diff --git a/drivers/bluetooth/hci_uart.h b/drivers/bluetooth/hci_uart.h
index 687aa7e..4dc8ab3 100644
--- a/drivers/bluetooth/hci_uart.h
+++ b/drivers/bluetooth/hci_uart.h
@@ -35,7 +35,7 @@
#define HCIUARTGETFLAGS _IOR('U', 204, int)
/* UART protocols */
-#define HCI_UART_MAX_PROTO 7
+#define HCI_UART_MAX_PROTO 8
#define HCI_UART_H4 0
#define HCI_UART_BCSP 1
@@ -44,6 +44,7 @@
#define HCI_UART_LL 4
#define HCI_UART_ATH3K 5
#define HCI_UART_INTEL 6
+#define HCI_UART_BCM 7
#define HCI_UART_RAW_DEVICE 0
#define HCI_UART_RESET_ON_INIT 1
@@ -123,3 +124,7 @@
#ifdef CONFIG_BT_HCIUART_INTEL
int intel_set_bdaddr(struct hci_dev *hdev, const bdaddr_t *bdaddr);
#endif
+
+#ifdef CONFIG_BT_HCIUART_BCM
+int bcm_set_bdaddr(struct hci_dev *hdev, const bdaddr_t *bdaddr);
+#endif