path: root/Documentation/hwmon/adt7410
diff options
Diffstat (limited to 'Documentation/hwmon/adt7410')
1 files changed, 60 insertions, 0 deletions
diff --git a/Documentation/hwmon/adt7410 b/Documentation/hwmon/adt7410
new file mode 100644
index 00000000..58150c48
--- /dev/null
+++ b/Documentation/hwmon/adt7410
@@ -0,0 +1,60 @@
+Kernel driver adt7410
+Supported chips:
+ * Analog Devices ADT7410
+ Prefix: 'adt7410'
+ Addresses scanned: None
+ Datasheet: Publicly available at the Analog Devices website
+ http://www.analog.com/static/imported-files/data_sheets/ADT7410.pdf
+ * Analog Devices ADT7420
+ Prefix: 'adt7420'
+ Addresses scanned: None
+ Datasheet: Publicly available at the Analog Devices website
+ http://www.analog.com/static/imported-files/data_sheets/ADT7420.pdf
+Author: Hartmut Knaack <knaack.h@gmx.de>
+The ADT7410 is a temperature sensor with rated temperature range of -55°C to
++150°C. It has a high accuracy of +/-0.5°C and can be operated at a resolution
+of 13 bits (0.0625°C) or 16 bits (0.0078°C). The sensor provides an INT pin to
+indicate that a minimum or maximum temperature set point has been exceeded, as
+well as a critical temperature (CT) pin to indicate that the critical
+temperature set point has been exceeded. Both pins can be set up with a common
+hysteresis of 0°C - 15°C and a fault queue, ranging from 1 to 4 events. Both
+pins can individually set to be active-low or active-high, while the whole
+device can either run in comparator mode or interrupt mode. The ADT7410
+supports continous temperature sampling, as well as sampling one temperature
+value per second or even justget one sample on demand for power saving.
+Besides, it can completely power down its ADC, if power management is
+The ADT7420 is register compatible, the only differences being the package,
+a slightly narrower operating temperature range (-40°C to +150°C), and a
+better accuracy (0.25°C instead of 0.50°C.)
+Configuration Notes
+Since the device uses one hysteresis value, which is an offset to minimum,
+maximum and critical temperature, it can only be set for temp#_max_hyst.
+However, temp#_min_hyst and temp#_crit_hyst show their corresponding
+The device is set to 16 bit resolution and comparator mode.
+temp#_input - temperature input
+temp#_min - temperature minimum setpoint
+temp#_max - temperature maximum setpoint
+temp#_crit - critical temperature setpoint
+temp#_min_hyst - hysteresis for temperature minimum (read-only)
+temp#_max_hyst - hysteresis for temperature maximum (read/write)
+temp#_crit_hyst - hysteresis for critical temperature (read-only)
+temp#_min_alarm - temperature minimum alarm flag
+temp#_max_alarm - temperature maximum alarm flag
+temp#_crit_alarm - critical temperature alarm flag