peter.maydell/qemu-arm.git - This qemu repo is mostly a place to put together pull requests for upstream

Age	Commit message (Expand)	Author
2007-11-11	Fix PowerPC boot device selection.	j_mayer
2007-11-11	mips_r4k warning fixes.	pbrook
2007-11-11	More generic boot devices specification, allowing more devices to be specified	j_mayer
2007-11-11	ARMv7 support.	pbrook
2007-11-10	Fix build failure.	pbrook
2007-11-10	Add dummy m68k board.	pbrook
2007-11-10	Fix 64-bit host printf format mismatches.	pbrook
2007-11-10	added cpu_model parameter to cpu_init()	bellard
2007-11-09	Fix typo, spotted by Samuel Thibault.	ths
2007-11-09	Move kernel loader parameters from the cpu state to being board specific.	ths
2007-11-08	Revert "Last AIO Patch" as requested by Fabrice, it is incomplete and	ths
2007-11-08	added -cpu option for x86 (initial patch by Dan Kenigsberg)	bellard
2007-11-07	removed traces	bellard
2007-11-07	added -startdate option	bellard
2007-11-05	No functional changes: remove dead code and fix indentation & wrapping lines.	j_mayer
2007-11-04	Zeroing ITR shouldn't ack irq zero.	balrog
2007-11-04	Change sysctrl register to 32 bits (original patch by Robert Reif)	blueswir1
2007-11-04	Fix memory corruption: bdrv_read/write API has been changed to take	j_mayer
2007-11-04	Fix Solaris breakage	blueswir1
2007-11-04	Add register mappings in DSP space (must be accessible for MPU too).	balrog
2007-11-04	Constification	blueswir1
2007-11-04	Remove target dependent code	blueswir1
2007-11-04	Make accesses with wrong width also work as apparently real hardware allows t...	balrog
2007-11-04	Fix grackle (in fact MPC106) PCI host bridge header	j_mayer
2007-11-04	Fix PowerMac NVRAM device.	j_mayer
2007-11-03	Split I^2C controller out of hw/omap.c.	balrog
2007-11-03	Implement OMAP on-chip RTC (Linux guest date/time now matches with host).	balrog
2007-11-03	Initial OMAP I^2C controller implementation (communication not tested).	balrog
2007-11-03	Add OMAP Pulse-width Tone module.	balrog
2007-11-03	Implement OMAP PWL (backlight) module.	balrog
2007-11-03	The PINT/DAV pin is active low in the chip spec, not inverted on the board.	balrog
2007-10-31	Add copyright and license header.	ths
2007-10-31	Set boot sequence from command line (Dan Kenigsberg).	balrog
2007-10-31	OHCI USB isochronous transfers support (Arnon Gilboa).	balrog
2007-10-29	Add a qemu_irq_invert() shortcut for inverting a signal.	balrog
2007-10-29	Add a TI TSC2102 chip (touchscreen/ADC/audio-CODEC controller).	balrog
2007-10-29	Fix PreP PCI IRQ mapping.	j_mayer
2007-10-29	Temporary hack to avoid Qemu crash at PowerPC reset time.	j_mayer
2007-10-29	Implement PreP reset port.	j_mayer
2007-10-29	PowerPC 601 / 620 / 970 need a 1MB firmware.	j_mayer
2007-10-29	Implement OMAP MicroWire controller.	balrog
2007-10-28	* sort the PowerPC target object files	j_mayer
2007-10-28	Give an opaque to the m48t59 direct access routines to make it easier	j_mayer
2007-10-28	Add OMAP Shared GPIO module.	balrog
2007-10-28	Handle MMC card insertion/removal/readonly signals.	balrog
2007-10-28	Add PalmT\|E matrix keypad connected to OMAP GPIOs.	balrog
2007-10-28	Implement OMAP1 MPU I/O module.	balrog
2007-10-28	Less debug noise from the mipsnet driver.	ths
2007-10-21	Bugfix: now PCI NICs really work on PowerPC PreP platform.	j_mayer
2007-10-21	Allow use of PCI NICs on PowerPC PreP platform.	j_mayer