# SPDX-License-Identifier: GPL-2.0-only # # Qualcomm network device configuration # config NET_VENDOR_QUALCOMM bool "Qualcomm devices" default y ---help--- If you have a network (Ethernet) card belonging to this class, say Y. Note that the answer to this question doesn't directly affect the kernel: saying N will just cause the configurator to skip all the questions about Qualcomm cards. If you say Y, you will be asked for your specific card in the following questions. if NET_VENDOR_QUALCOMM config QCA7000 tristate help This enables support for the Qualcomm Atheros QCA7000. config QCA7000_SPI tristate "Qualcomm Atheros QCA7000 SPI support" select QCA7000 depends on SPI_MASTER && OF ---help--- This SPI protocol driver supports the Qualcomm Atheros QCA7000. To compile this driver as a module, choose M here. The module will be called qcaspi. config QCA7000_UART tristate "Qualcomm Atheros QCA7000 UART support" select QCA7000 depends on SERIAL_DEV_BUS && OF ---help--- This UART protocol driver supports the Qualcomm Atheros QCA7000. Currently the driver assumes these device UART settings: Data bits: 8 Parity: None Stop bits: 1 Flow control: None To compile this driver as a module, choose M here. The module will be called qcauart. config QCOM_EMAC tristate "Qualcomm Technologies, Inc. EMAC Gigabit Ethernet support" depends on HAS_DMA && HAS_IOMEM select CRC32 select PHYLIB ---help--- This driver supports the Qualcomm Technologies, Inc. Gigabit Ethernet Media Access Controller (EMAC). The controller supports IEEE 802.3-2002, half-duplex mode at 10/100 Mb/s, full-duplex mode at 10/100/1000Mb/s, Wake On LAN (WOL) for low power, Receive-Side Scaling (RSS), and IEEE 1588-2008 Precision Clock Synchronization Protocol. source "drivers/net/ethernet/qualcomm/rmnet/Kconfig" endif # NET_VENDOR_QUALCOMM