/* * Thunderbolt Cactus Ridge driver - NHI registers * * Copyright (c) 2014 Andreas Noever */ #ifndef DSL3510_REGS_H_ #define DSL3510_REGS_H_ #include enum ring_flags { RING_FLAG_ISOCH_ENABLE = 1 << 27, /* TX only? */ RING_FLAG_E2E_FLOW_CONTROL = 1 << 28, RING_FLAG_PCI_NO_SNOOP = 1 << 29, RING_FLAG_RAW = 1 << 30, /* ignore EOF/SOF mask, include checksum */ RING_FLAG_ENABLE = 1 << 31, }; enum ring_desc_flags { RING_DESC_ISOCH = 0x1, /* TX only? */ RING_DESC_COMPLETED = 0x2, /* set by NHI */ RING_DESC_POSTED = 0x4, /* always set this */ RING_DESC_INTERRUPT = 0x8, /* request an interrupt on completion */ }; /** * struct ring_desc - TX/RX ring entry * * For TX set length/eof/sof. * For RX length/eof/sof are set by the NHI. */ struct ring_desc { u64 phys; u32 length:12; u32 eof:4; u32 sof:4; enum ring_desc_flags flags:12; u32 time; /* write zero */ } __packed; /* NHI registers in bar 0 */ /* * 16 bytes per entry, one entry for every hop (REG_HOP_COUNT) * 00: physical pointer to an array of struct ring_desc * 08: ring tail (set by NHI) * 10: ring head (index of first non posted descriptor) * 12: descriptor count */ #define REG_TX_RING_BASE 0x00000 /* * 16 bytes per entry, one entry for every hop (REG_HOP_COUNT) * 00: physical pointer to an array of struct ring_desc * 08: ring head (index of first not posted descriptor) * 10: ring tail (set by NHI) * 12: descriptor count * 14: max frame sizes (anything larger than 0x100 has no effect) */ #define REG_RX_RING_BASE 0x08000 /* * 32 bytes per entry, one entry for every hop (REG_HOP_COUNT) * 00: enum_ring_flags * 04: isoch time stamp ?? (write 0) * ..: unknown */ #define REG_TX_OPTIONS_BASE 0x19800 /* * 32 bytes per entry, one entry for every hop (REG_HOP_COUNT) * 00: enum ring_flags * If RING_FLAG_E2E_FLOW_CONTROL is set then bits 13-23 must be set to * the corresponding TX hop id. * 04: EOF/SOF mask (ignored for RING_FLAG_RAW rings) * ..: unknown */ #define REG_RX_OPTIONS_BASE 0x29800 /* * three bitfields: tx, rx, rx overflow * Every bitfield contains one bit for every hop (REG_HOP_COUNT). Registers are * cleared on read. New interrupts are fired only after ALL registers have been * read (even those containing only disabled rings). */ #define REG_RING_NOTIFY_BASE 0x37800 #define RING_NOTIFY_REG_COUNT(nhi) ((31 + 3 * nhi->hop_count) / 32) /* * two bitfields: rx, tx * Both bitfields contains one bit for every hop (REG_HOP_COUNT). To * enable/disable interrupts set/clear the corresponding bits. */ #define REG_RING_INTERRUPT_BASE 0x38200 #define RING_INTERRUPT_REG_COUNT(nhi) ((31 + 2 * nhi->hop_count) / 32) /* The last 11 bits contain the number of hops supported by the NHI port. */ #define REG_HOP_COUNT 0x39640 #endif