From f60db98eaa67e02915f01e11933501127bc004b0 Mon Sep 17 00:00:00 2001 From: Roger Quadros Date: Mon, 26 Jan 2015 14:15:30 +0200 Subject: ARM: dts: am57xx-beagle-x15: Add extcon nodes for USB On this EVM, the USB cable state has to be determined via the ID pin tied to a GPIO line. We use the gpio-usb-extcon driver to read the ID pin and the extcon framework to forward the USB cable state information to the USB driver so the controller can be configured in the right mode (host/peripheral). NOTE: the ports on this board cannot switch roles. They are configured either host or peripheral by hardwiring the respective ID pins. Signed-off-by: Roger Quadros Signed-off-by: Tony Lindgren --- arch/arm/boot/dts/am57xx-beagle-x15.dts | 33 +++++++++++++++++++++++++++++++++ 1 file changed, 33 insertions(+) diff --git a/arch/arm/boot/dts/am57xx-beagle-x15.dts b/arch/arm/boot/dts/am57xx-beagle-x15.dts index c5d4ceabdd80..0e889eb62a59 100644 --- a/arch/arm/boot/dts/am57xx-beagle-x15.dts +++ b/arch/arm/boot/dts/am57xx-beagle-x15.dts @@ -88,6 +88,20 @@ gpio-fan,speed-map = <0 0>, <13000 1>; }; + + extcon_usb1: extcon_usb1 { + compatible = "linux,extcon-usb-gpio"; + id-gpio = <&gpio7 25 GPIO_ACTIVE_HIGH>; + pinctrl-names = "default"; + pinctrl-0 = <&extcon_usb1_pins>; + }; + + extcon_usb2: extcon_usb2 { + compatible = "linux,extcon-usb-gpio"; + id-gpio = <&gpio7 24 GPIO_ACTIVE_HIGH>; + pinctrl-names = "default"; + pinctrl-0 = <&extcon_usb2_pins>; + }; }; &dra7_pmx_core { @@ -252,6 +266,17 @@ >; }; + extcon_usb1_pins: extcon_usb1_pins { + pinctrl-single,pins = < + 0x3ec (PIN_INPUT_PULLUP | MUX_MODE14) /* uart1_rtsn.gpio7_25 */ + >; + }; + + extcon_usb2_pins: extcon_usb2_pins { + pinctrl-single,pins = < + 0x3e8 (PIN_INPUT_PULLUP | MUX_MODE14) /* uart1_ctsn.gpio7_24 */ + >; + }; }; &i2c1 { @@ -523,3 +548,11 @@ pinctrl-names = "default"; pinctrl-0 = <&usb1_pins>; }; + +&omap_dwc3_1 { + extcon = <&extcon_usb1>; +}; + +&omap_dwc3_2 { + extcon = <&extcon_usb2>; +}; -- cgit v1.2.3