From 233c3dda5cd1bb26fa871b94db17627117e51026 Mon Sep 17 00:00:00 2001 From: Greg Kroah-Hartman Date: Fri, 1 Nov 2013 09:18:25 -0700 Subject: Revert "usb: pl2303: add two comments concerning the supported baud rates with HX chips" MIME-Version: 1.0 Content-Type: text/plain; charset=UTF-8 Content-Transfer-Encoding: 8bit This reverts commit c23bda365dfbf56aa4d6d4a97f83136c36050e01. Revert all of the pl2303 changes that went into 3.12-rc1 and -rc2 as they cause regressions on some versions of the chip. This will all be revisited for later kernel versions when we can figure out how to handle this in a way that does not break working devices. Reported-by: Mika Westerberg Cc: Frank Schäfer Acked-by: Johan Hovold Signed-off-by: Greg Kroah-Hartman --- drivers/usb/serial/pl2303.c | 12 ------------ 1 file changed, 12 deletions(-) diff --git a/drivers/usb/serial/pl2303.c b/drivers/usb/serial/pl2303.c index 6638c5d9079d..09fb55cf3be7 100644 --- a/drivers/usb/serial/pl2303.c +++ b/drivers/usb/serial/pl2303.c @@ -281,12 +281,6 @@ static int pl2303_baudrate_encode_direct(int baud, enum pl2303_type type, 4800, 7200, 9600, 14400, 19200, 28800, 38400, 57600, 115200, 230400, 460800, 614400, 921600, 1228800, 2457600, 3000000, 6000000 }; - /* - * NOTE: The PL2303HX (tested with rev. 3A) also supports the following - * baud rates: 128000, 134400, 161280, 201600, 268800, 403200, 806400. - * As long as we are not using this encoding method for them, there is - * no point in complicating the code to support them. - */ int i; /* Set baudrate to nearest supported value */ @@ -400,12 +394,6 @@ static void pl2303_encode_baudrate(struct tty_struct *tty, * => supported by all chip types * 2) Divisor based method: encodes a divisor to a base value (12MHz*32) * => supported by HX chips (and likely not by type_0/1 chips) - * - * NOTE: Although the divisor based baud rate encoding method is much - * more flexible, some of the standard baud rate values can not be - * realized exactly. But the difference is very small (max. 0.2%) and - * the device likely uses the same baud rate generator for both methods - * so that there is likley no difference. */ if (type != HX) baud = pl2303_baudrate_encode_direct(baud, type, buf); -- cgit v1.2.3