diff options
Diffstat (limited to 'drivers/gpu/drm/i915/intel_dsi.c')
| -rw-r--r-- | drivers/gpu/drm/i915/intel_dsi.c | 51 |
1 files changed, 39 insertions, 12 deletions
diff --git a/drivers/gpu/drm/i915/intel_dsi.c b/drivers/gpu/drm/i915/intel_dsi.c index b5a5558ecd63..4a601cf90f16 100644 --- a/drivers/gpu/drm/i915/intel_dsi.c +++ b/drivers/gpu/drm/i915/intel_dsi.c @@ -31,6 +31,7 @@ #include <drm/drm_panel.h> #include <drm/drm_mipi_dsi.h> #include <linux/slab.h> +#include <linux/gpio/consumer.h> #include "i915_drv.h" #include "intel_drv.h" #include "intel_dsi.h" @@ -261,11 +262,6 @@ static inline bool is_cmd_mode(struct intel_dsi *intel_dsi) return intel_dsi->operation_mode == INTEL_DSI_COMMAND_MODE; } -static void intel_dsi_hot_plug(struct intel_encoder *encoder) -{ - DRM_DEBUG_KMS("\n"); -} - static bool intel_dsi_compute_config(struct intel_encoder *encoder, struct intel_crtc_state *config) { @@ -401,6 +397,8 @@ static void intel_dsi_enable(struct intel_encoder *encoder) intel_dsi_port_enable(encoder); } + + intel_panel_enable_backlight(intel_dsi->attached_connector); } static void intel_dsi_pre_enable(struct intel_encoder *encoder) @@ -415,15 +413,21 @@ static void intel_dsi_pre_enable(struct intel_encoder *encoder) DRM_DEBUG_KMS("\n"); + /* Panel Enable over CRC PMIC */ + if (intel_dsi->gpio_panel) + gpiod_set_value_cansleep(intel_dsi->gpio_panel, 1); + + msleep(intel_dsi->panel_on_delay); + /* Disable DPOunit clock gating, can stall pipe * and we need DPLL REFA always enabled */ tmp = I915_READ(DPLL(pipe)); - tmp |= DPLL_REFA_CLK_ENABLE_VLV; + tmp |= DPLL_REF_CLK_ENABLE_VLV; I915_WRITE(DPLL(pipe), tmp); /* update the hw state for DPLL */ - intel_crtc->config->dpll_hw_state.dpll = DPLL_INTEGRATED_CLOCK_VLV | - DPLL_REFA_CLK_ENABLE_VLV; + intel_crtc->config->dpll_hw_state.dpll = DPLL_INTEGRATED_REF_CLK_VLV | + DPLL_REF_CLK_ENABLE_VLV | DPLL_VGA_MODE_DIS; tmp = I915_READ(DSPCLK_GATE_D); tmp |= DPOUNIT_CLOCK_GATE_DISABLE; @@ -432,8 +436,6 @@ static void intel_dsi_pre_enable(struct intel_encoder *encoder) /* put device in ready state */ intel_dsi_device_ready(encoder); - msleep(intel_dsi->panel_on_delay); - drm_panel_prepare(intel_dsi->panel); for_each_dsi_port(port, intel_dsi->ports) @@ -461,6 +463,8 @@ static void intel_dsi_pre_disable(struct intel_encoder *encoder) DRM_DEBUG_KMS("\n"); + intel_panel_disable_backlight(intel_dsi->attached_connector); + if (is_vid_mode(intel_dsi)) { /* Send Shutdown command to the panel in LP mode */ for_each_dsi_port(port, intel_dsi->ports) @@ -576,6 +580,10 @@ static void intel_dsi_post_disable(struct intel_encoder *encoder) msleep(intel_dsi->panel_off_delay); msleep(intel_dsi->panel_pwr_cycle_delay); + + /* Panel Disable over CRC PMIC */ + if (intel_dsi->gpio_panel) + gpiod_set_value_cansleep(intel_dsi->gpio_panel, 0); } static bool intel_dsi_get_hw_state(struct intel_encoder *encoder, @@ -955,6 +963,11 @@ static void intel_dsi_encoder_destroy(struct drm_encoder *encoder) /* XXX: Logically this call belongs in the panel driver. */ drm_panel_remove(intel_dsi->panel); } + + /* dispose of the gpios */ + if (intel_dsi->gpio_panel) + gpiod_put(intel_dsi->gpio_panel); + intel_encoder_destroy(encoder); } @@ -969,7 +982,7 @@ static const struct drm_connector_helper_funcs intel_dsi_connector_helper_funcs }; static const struct drm_connector_funcs intel_dsi_connector_funcs = { - .dpms = intel_connector_dpms, + .dpms = drm_atomic_helper_connector_dpms, .detect = intel_dsi_detect, .destroy = intel_dsi_connector_destroy, .fill_modes = drm_helper_probe_single_connector_modes, @@ -1022,7 +1035,6 @@ void intel_dsi_init(struct drm_device *dev) drm_encoder_init(dev, encoder, &intel_dsi_funcs, DRM_MODE_ENCODER_DSI); /* XXX: very likely not all of these are needed */ - intel_encoder->hot_plug = intel_dsi_hot_plug; intel_encoder->compute_config = intel_dsi_compute_config; intel_encoder->pre_pll_enable = intel_dsi_pre_pll_enable; intel_encoder->pre_enable = intel_dsi_pre_enable; @@ -1071,6 +1083,20 @@ void intel_dsi_init(struct drm_device *dev) goto err; } + /* + * In case of BYT with CRC PMIC, we need to use GPIO for + * Panel control. + */ + if (dev_priv->vbt.dsi.config->pwm_blc == PPS_BLC_PMIC) { + intel_dsi->gpio_panel = + gpiod_get(dev->dev, "panel", GPIOD_OUT_HIGH); + + if (IS_ERR(intel_dsi->gpio_panel)) { + DRM_ERROR("Failed to own gpio for panel control\n"); + intel_dsi->gpio_panel = NULL; + } + } + intel_encoder->type = INTEL_OUTPUT_DSI; intel_encoder->cloneable = 0; drm_connector_init(dev, connector, &intel_dsi_connector_funcs, @@ -1104,6 +1130,7 @@ void intel_dsi_init(struct drm_device *dev) } intel_panel_init(&intel_connector->panel, fixed_mode, NULL); + intel_panel_setup_backlight(connector, INVALID_PIPE); return; |