path: root/Documentation/i2c/i2c-stub
diff options
Diffstat (limited to 'Documentation/i2c/i2c-stub')
1 files changed, 13 insertions, 2 deletions
diff --git a/Documentation/i2c/i2c-stub b/Documentation/i2c/i2c-stub
index d6dcb138abf5..9cc081e69764 100644
--- a/Documentation/i2c/i2c-stub
+++ b/Documentation/i2c/i2c-stub
@@ -6,9 +6,12 @@ This module is a very simple fake I2C/SMBus driver. It implements four
types of SMBus commands: write quick, (r/w) byte, (r/w) byte data, and
(r/w) word data.
+You need to provide a chip address as a module parameter when loading
+this driver, which will then only react to SMBus commands to this address.
No hardware is needed nor associated with this module. It will accept write
-quick commands to all addresses; it will respond to the other commands (also
-to all addresses) by reading from or writing to an array in memory. It will
+quick commands to one address; it will respond to the other commands (also
+to one address) by reading from or writing to an array in memory. It will
also spam the kernel logs for every command it handles.
A pointer register with auto-increment is implemented for all byte
@@ -21,6 +24,11 @@ The typical use-case is like this:
3. load the target sensors chip driver module
4. observe its behavior in the kernel log
+int chip_addr:
+ The SMBus address to emulate a chip at.
There are independent arrays for byte/data and word/data commands. Depending
@@ -33,6 +41,9 @@ If the hardware for your driver has banked registers (e.g. Winbond sensors
chips) this module will not work well - although it could be extended to
support that pretty easily.
+Only one chip address is supported - although this module could be
+extended to support more.
If you spam it hard enough, printk can be lossy. This module really wants
something like relayfs.