diff options
Diffstat (limited to 'Documentation/devicetree/bindings/interrupt-controller/brcm,bcm7120-l2-intc.txt')
| -rw-r--r-- | Documentation/devicetree/bindings/interrupt-controller/brcm,bcm7120-l2-intc.txt | 26 |
1 files changed, 18 insertions, 8 deletions
diff --git a/Documentation/devicetree/bindings/interrupt-controller/brcm,bcm7120-l2-intc.txt b/Documentation/devicetree/bindings/interrupt-controller/brcm,bcm7120-l2-intc.txt index ff812a8a82bc..bae1f2187226 100644 --- a/Documentation/devicetree/bindings/interrupt-controller/brcm,bcm7120-l2-intc.txt +++ b/Documentation/devicetree/bindings/interrupt-controller/brcm,bcm7120-l2-intc.txt @@ -13,7 +13,12 @@ Such an interrupt controller has the following hardware design: or if they will output an interrupt signal at this 2nd level interrupt controller, in particular for UARTs -- not all 32-bits within the interrupt controller actually map to an interrupt +- typically has one 32-bit enable word and one 32-bit status word, but on + some hardware may have more than one enable/status pair + +- no atomic set/clear operations + +- not all bits within the interrupt controller actually map to an interrupt The typical hardware layout for this controller is represented below: @@ -48,7 +53,9 @@ The typical hardware layout for this controller is represented below: Required properties: - compatible: should be "brcm,bcm7120-l2-intc" -- reg: specifies the base physical address and size of the registers +- reg: specifies the base physical address and size of the registers; + multiple pairs may be specified, with the first pair handling IRQ offsets + 0..31 and the second pair handling 32..63 - interrupt-controller: identifies the node as an interrupt controller - #interrupt-cells: specifies the number of cells needed to encode an interrupt source, should be 1. @@ -59,18 +66,21 @@ Required properties: - brcm,int-map-mask: 32-bits bit mask describing how many and which interrupts are wired to this 2nd level interrupt controller, and how they match their respective interrupt parents. Should match exactly the number of interrupts - specified in the 'interrupts' property. + specified in the 'interrupts' property, multiplied by the number of + enable/status register pairs implemented by this controller. For + multiple parent IRQs with multiple enable/status words, this looks like: + <irq0_w0 irq0_w1 irq1_w0 irq1_w1 ...> Optional properties: - brcm,irq-can-wake: if present, this means the L2 controller can be used as a wakeup source for system suspend/resume. -- brcm,int-fwd-mask: if present, a 32-bits bit mask to configure for the - interrupts which have a mux gate, typically UARTs. Setting these bits will - make their respective interrupts outputs bypass this 2nd level interrupt - controller completely, it completely transparent for the interrupt controller - parent +- brcm,int-fwd-mask: if present, a bit mask to configure the interrupts which + have a mux gate, typically UARTs. Setting these bits will make their + respective interrupt outputs bypass this 2nd level interrupt controller + completely; it is completely transparent for the interrupt controller + parent. This should have one 32-bit word per enable/status pair. Example: |