|author||Simon Budig <email@example.com>||2012-07-24 23:29:36 -0700|
|committer||Dmitry Torokhov <firstname.lastname@example.org>||2012-07-24 23:55:03 -0700|
Input: add driver for FT5x06 based EDT displays
This is a driver for the EDT "Polytouch" family of touch controllers based on the FocalTech FT5x06 line of chips. Signed-off-by: Simon Budig <email@example.com> Reviewed-by: Henrik Rydberg <firstname.lastname@example.org> Signed-off-by: Dmitry Torokhov <email@example.com>
Diffstat (limited to 'Documentation/input')
1 files changed, 54 insertions, 0 deletions
diff --git a/Documentation/input/edt-ft5x06.txt b/Documentation/input/edt-ft5x06.txt
new file mode 100644
@@ -0,0 +1,54 @@
+EDT ft5x06 based Polytouch devices
+The edt-ft5x06 driver is useful for the EDT "Polytouch" family of capacitive
+touch screens. Note that it is *not* suitable for other devices based on the
+focaltec ft5x06 devices, since they contain vendor-specific firmware. In
+particular this driver is not suitable for the Nook tablet.
+It has been tested with the following devices:
+ * EP0350M06
+ * EP0430M06
+ * EP0570M06
+ * EP0700M06
+The driver allows configuration of the touch screen via a set of sysfs files:
+ allows setting the "click"-threshold in the range from 20 to 80.
+ allows setting the sensitivity in the range from 0 to 31. Note that
+ lower values indicate higher sensitivity.
+ allows setting the edge compensation in the range from 0 to 31.
+ allows setting the report rate in the range from 3 to 14.
+For debugging purposes the driver provides a few files in the debug
+filesystem (if available in the kernel). In /sys/kernel/debug/edt_ft5x06
+you'll find the following files:
+ (readonly) contains the number of sensor fields in X- and
+ allows switching the sensor between "factory mode" and "operation
+ mode" by writing "1" or "0" to it. In factory mode (1) it is
+ possible to get the raw data from the sensor. Note that in factory
+ mode regular events don't get delivered and the options described
+ above are unavailable.
+ contains num_x * num_y big endian 16 bit values describing the raw
+ values for each sensor field. Note that each read() call on this
+ files triggers a new readout. It is recommended to provide a buffer
+ big enough to contain num_x * num_y * 2 bytes.
+Note that reading raw_data gives a I/O error when the device is not in factory
+mode. The same happens when reading/writing to the parameter files when the
+device is not in regular operation mode.