diff options
Diffstat (limited to 'drivers/staging/quatech_usb2/quatech_usb2.c')
| -rw-r--r-- | drivers/staging/quatech_usb2/quatech_usb2.c | 12 |
1 files changed, 6 insertions, 6 deletions
diff --git a/drivers/staging/quatech_usb2/quatech_usb2.c b/drivers/staging/quatech_usb2/quatech_usb2.c index c45b09ed0d3..ca098cabc2b 100644 --- a/drivers/staging/quatech_usb2/quatech_usb2.c +++ b/drivers/staging/quatech_usb2/quatech_usb2.c @@ -148,7 +148,7 @@ static struct usb_driver quausb2_usb_driver = { * value of the line status flags from the port * @shadowMSR: Last received state of the modem status register, holds * the value of the modem status received from the port - * @rcv_flush: Flag indicating that a receive flush has occured on + * @rcv_flush: Flag indicating that a receive flush has occurred on * the hardware. * @xmit_flush: Flag indicating that a transmit flush has been processed by * the hardware. @@ -156,7 +156,7 @@ static struct usb_driver quausb2_usb_driver = { * includes the size (excluding header) of URBs that have been submitted but * have not yet been sent to to the device, and bytes that have been sent out * of the port but not yet reported sent by the "xmit_empty" messages (which - * indicate the number of bytes sent each time they are recieved, despite the + * indicate the number of bytes sent each time they are received, despite the * misleading name). * - Starts at zero when port is initialised. * - is incremented by the size of the data to be written (no headers) @@ -649,7 +649,7 @@ static void qt2_close(struct usb_serial_port *port) /* although the USB side is now empty, the UART itself may * still be pushing characters out over the line, so we have to * wait testing the actual line status until the lines change - * indicating that the data is done transfering. */ + * indicating that the data is done transferring. */ /* FIXME: slow this polling down so it doesn't run the USB bus flat out * if it actually has to spend any time in this loop (which it normally * doesn't because the buffer is nearly empty) */ @@ -726,7 +726,7 @@ static int qt2_write(struct tty_struct *tty, struct usb_serial_port *port, return 0; } else if (port_extra->tx_pending_bytes >= QT2_FIFO_DEPTH) { /* buffer is full (==). > should not occur, but would indicate - * that an overflow had occured */ + * that an overflow had occurred */ dbg("%s(): port transmit buffer is full!", __func__); /* schedule_work(&port->work); commented in vendor driver */ return 0; @@ -823,7 +823,7 @@ static int qt2_write_room(struct tty_struct *tty) * reduce the free space count by the size of the dispatched write. * When a "transmit empty" message comes back up the USB read stream, * we decrement the count by the number of bytes reported sent, thus - * keeping track of the difference between sent and recieved bytes. + * keeping track of the difference between sent and received bytes. */ room = (QT2_FIFO_DEPTH - port_extra->tx_pending_bytes); @@ -1795,7 +1795,7 @@ static void qt2_process_rx_char(struct usb_serial_port *port, } } -/** @brief Retreive the value of a register from the device +/** @brief Retrieve the value of a register from the device * * Issues a GET_REGISTER vendor-spcific request over the USB control * pipe to obtain a value back from a specific register on a specific |