diff options
Diffstat (limited to 'drivers/net/myri10ge/myri10ge_mcp.h')
| -rw-r--r-- | drivers/net/myri10ge/myri10ge_mcp.h | 205 |
1 files changed, 205 insertions, 0 deletions
diff --git a/drivers/net/myri10ge/myri10ge_mcp.h b/drivers/net/myri10ge/myri10ge_mcp.h new file mode 100644 index 00000000000..0a6cae6cb18 --- /dev/null +++ b/drivers/net/myri10ge/myri10ge_mcp.h @@ -0,0 +1,205 @@ +#ifndef __MYRI10GE_MCP_H__ +#define __MYRI10GE_MCP_H__ + +#define MXGEFW_VERSION_MAJOR 1 +#define MXGEFW_VERSION_MINOR 4 + +/* 8 Bytes */ +struct mcp_dma_addr { + u32 high; + u32 low; +}; + +/* 4 Bytes */ +struct mcp_slot { + u16 checksum; + u16 length; +}; + +/* 64 Bytes */ +struct mcp_cmd { + u32 cmd; + u32 data0; /* will be low portion if data > 32 bits */ + /* 8 */ + u32 data1; /* will be high portion if data > 32 bits */ + u32 data2; /* currently unused.. */ + /* 16 */ + struct mcp_dma_addr response_addr; + /* 24 */ + u8 pad[40]; +}; + +/* 8 Bytes */ +struct mcp_cmd_response { + u32 data; + u32 result; +}; + +/* + * flags used in mcp_kreq_ether_send_t: + * + * The SMALL flag is only needed in the first segment. It is raised + * for packets that are total less or equal 512 bytes. + * + * The CKSUM flag must be set in all segments. + * + * The PADDED flags is set if the packet needs to be padded, and it + * must be set for all segments. + * + * The MXGEFW_FLAGS_ALIGN_ODD must be set if the cumulative + * length of all previous segments was odd. + */ + +#define MXGEFW_FLAGS_SMALL 0x1 +#define MXGEFW_FLAGS_TSO_HDR 0x1 +#define MXGEFW_FLAGS_FIRST 0x2 +#define MXGEFW_FLAGS_ALIGN_ODD 0x4 +#define MXGEFW_FLAGS_CKSUM 0x8 +#define MXGEFW_FLAGS_TSO_LAST 0x8 +#define MXGEFW_FLAGS_NO_TSO 0x10 +#define MXGEFW_FLAGS_TSO_CHOP 0x10 +#define MXGEFW_FLAGS_TSO_PLD 0x20 + +#define MXGEFW_SEND_SMALL_SIZE 1520 +#define MXGEFW_MAX_MTU 9400 + +union mcp_pso_or_cumlen { + u16 pseudo_hdr_offset; + u16 cum_len; +}; + +#define MXGEFW_MAX_SEND_DESC 12 +#define MXGEFW_PAD 2 + +/* 16 Bytes */ +struct mcp_kreq_ether_send { + u32 addr_high; + u32 addr_low; + u16 pseudo_hdr_offset; + u16 length; + u8 pad; + u8 rdma_count; + u8 cksum_offset; /* where to start computing cksum */ + u8 flags; /* as defined above */ +}; + +/* 8 Bytes */ +struct mcp_kreq_ether_recv { + u32 addr_high; + u32 addr_low; +}; + +/* Commands */ + +#define MXGEFW_CMD_OFFSET 0xf80000 + +enum myri10ge_mcp_cmd_type { + MXGEFW_CMD_NONE = 0, + /* Reset the mcp, it is left in a safe state, waiting + * for the driver to set all its parameters */ + MXGEFW_CMD_RESET, + + /* get the version number of the current firmware.. + * (may be available in the eeprom strings..? */ + MXGEFW_GET_MCP_VERSION, + + /* Parameters which must be set by the driver before it can + * issue MXGEFW_CMD_ETHERNET_UP. They persist until the next + * MXGEFW_CMD_RESET is issued */ + + MXGEFW_CMD_SET_INTRQ_DMA, + MXGEFW_CMD_SET_BIG_BUFFER_SIZE, /* in bytes, power of 2 */ + MXGEFW_CMD_SET_SMALL_BUFFER_SIZE, /* in bytes */ + + /* Parameters which refer to lanai SRAM addresses where the + * driver must issue PIO writes for various things */ + + MXGEFW_CMD_GET_SEND_OFFSET, + MXGEFW_CMD_GET_SMALL_RX_OFFSET, + MXGEFW_CMD_GET_BIG_RX_OFFSET, + MXGEFW_CMD_GET_IRQ_ACK_OFFSET, + MXGEFW_CMD_GET_IRQ_DEASSERT_OFFSET, + + /* Parameters which refer to rings stored on the MCP, + * and whose size is controlled by the mcp */ + + MXGEFW_CMD_GET_SEND_RING_SIZE, /* in bytes */ + MXGEFW_CMD_GET_RX_RING_SIZE, /* in bytes */ + + /* Parameters which refer to rings stored in the host, + * and whose size is controlled by the host. Note that + * all must be physically contiguous and must contain + * a power of 2 number of entries. */ + + MXGEFW_CMD_SET_INTRQ_SIZE, /* in bytes */ + + /* command to bring ethernet interface up. Above parameters + * (plus mtu & mac address) must have been exchanged prior + * to issuing this command */ + MXGEFW_CMD_ETHERNET_UP, + + /* command to bring ethernet interface down. No further sends + * or receives may be processed until an MXGEFW_CMD_ETHERNET_UP + * is issued, and all interrupt queues must be flushed prior + * to ack'ing this command */ + + MXGEFW_CMD_ETHERNET_DOWN, + + /* commands the driver may issue live, without resetting + * the nic. Note that increasing the mtu "live" should + * only be done if the driver has already supplied buffers + * sufficiently large to handle the new mtu. Decreasing + * the mtu live is safe */ + + MXGEFW_CMD_SET_MTU, + MXGEFW_CMD_GET_INTR_COAL_DELAY_OFFSET, /* in microseconds */ + MXGEFW_CMD_SET_STATS_INTERVAL, /* in microseconds */ + MXGEFW_CMD_SET_STATS_DMA, + + MXGEFW_ENABLE_PROMISC, + MXGEFW_DISABLE_PROMISC, + MXGEFW_SET_MAC_ADDRESS, + + MXGEFW_ENABLE_FLOW_CONTROL, + MXGEFW_DISABLE_FLOW_CONTROL, + + /* do a DMA test + * data0,data1 = DMA address + * data2 = RDMA length (MSH), WDMA length (LSH) + * command return data = repetitions (MSH), 0.5-ms ticks (LSH) + */ + MXGEFW_DMA_TEST +}; + +enum myri10ge_mcp_cmd_status { + MXGEFW_CMD_OK = 0, + MXGEFW_CMD_UNKNOWN, + MXGEFW_CMD_ERROR_RANGE, + MXGEFW_CMD_ERROR_BUSY, + MXGEFW_CMD_ERROR_EMPTY, + MXGEFW_CMD_ERROR_CLOSED, + MXGEFW_CMD_ERROR_HASH_ERROR, + MXGEFW_CMD_ERROR_BAD_PORT, + MXGEFW_CMD_ERROR_RESOURCES +}; + +/* 40 Bytes */ +struct mcp_irq_data { + u32 send_done_count; + + u32 link_up; + u32 dropped_link_overflow; + u32 dropped_link_error_or_filtered; + u32 dropped_runt; + u32 dropped_overrun; + u32 dropped_no_small_buffer; + u32 dropped_no_big_buffer; + u32 rdma_tags_available; + + u8 tx_stopped; + u8 link_down; + u8 stats_updated; + u8 valid; +}; + +#endif /* __MYRI10GE_MCP_H__ */ |