diff options
Diffstat (limited to 'drivers/net/ethernet/intel/e1000e/mac.c')
| -rw-r--r-- | drivers/net/ethernet/intel/e1000e/mac.c | 13 |
1 files changed, 4 insertions, 9 deletions
diff --git a/drivers/net/ethernet/intel/e1000e/mac.c b/drivers/net/ethernet/intel/e1000e/mac.c index db735644b312..b322011ec282 100644 --- a/drivers/net/ethernet/intel/e1000e/mac.c +++ b/drivers/net/ethernet/intel/e1000e/mac.c @@ -410,9 +410,6 @@ void e1000e_clear_hw_cntrs_base(struct e1000_hw *hw) * Checks to see of the link status of the hardware has changed. If a * change in link status has been detected, then we read the PHY registers * to get the current speed/duplex if link exists. - * - * Returns a negative error code (-E1000_ERR_*) or 0 (link down) or 1 (link - * up). **/ s32 e1000e_check_for_copper_link(struct e1000_hw *hw) { @@ -426,7 +423,7 @@ s32 e1000e_check_for_copper_link(struct e1000_hw *hw) * Change or Rx Sequence Error interrupt. */ if (!mac->get_link_status) - return 1; + return 0; /* First we want to see if the MII Status Register reports * link. If so, then we want to get the current speed/duplex @@ -450,7 +447,7 @@ s32 e1000e_check_for_copper_link(struct e1000_hw *hw) * we have already determined whether we have link or not. */ if (!mac->autoneg) - return 1; + return -E1000_ERR_CONFIG; /* Auto-Neg is enabled. Auto Speed Detection takes care * of MAC speed/duplex configuration. So we only need to @@ -464,12 +461,10 @@ s32 e1000e_check_for_copper_link(struct e1000_hw *hw) * different link partner. */ ret_val = e1000e_config_fc_after_link_up(hw); - if (ret_val) { + if (ret_val) e_dbg("Error configuring flow control\n"); - return ret_val; - } - return 1; + return ret_val; } /** |