diff options
Diffstat (limited to 'Documentation/networking/ip-sysctl.txt')
| -rw-r--r-- | Documentation/networking/ip-sysctl.txt | 99 |
1 files changed, 91 insertions, 8 deletions
diff --git a/Documentation/networking/ip-sysctl.txt b/Documentation/networking/ip-sysctl.txt index 006b39dec87..f350c69b2bb 100644 --- a/Documentation/networking/ip-sysctl.txt +++ b/Documentation/networking/ip-sysctl.txt @@ -487,6 +487,30 @@ tcp_dma_copybreak - INTEGER and CONFIG_NET_DMA is enabled. Default: 4096 +tcp_thin_linear_timeouts - BOOLEAN + Enable dynamic triggering of linear timeouts for thin streams. + If set, a check is performed upon retransmission by timeout to + determine if the stream is thin (less than 4 packets in flight). + As long as the stream is found to be thin, up to 6 linear + timeouts may be performed before exponential backoff mode is + initiated. This improves retransmission latency for + non-aggressive thin streams, often found to be time-dependent. + For more information on thin streams, see + Documentation/networking/tcp-thin.txt + Default: 0 + +tcp_thin_dupack - BOOLEAN + Enable dynamic triggering of retransmissions after one dupACK + for thin streams. If set, a check is performed upon reception + of a dupACK to determine if the stream is thin (less than 4 + packets in flight). As long as the stream is found to be thin, + data is retransmitted on the first received dupACK. This + improves retransmission latency for non-aggressive thin + streams, often found to be time-dependent. + For more information on thin streams, see + Documentation/networking/tcp-thin.txt + Default: 0 + UDP variables: udp_mem - vector of 3 INTEGERs: min, pressure, max @@ -564,6 +588,37 @@ ip_local_port_range - 2 INTEGERS (i.e. by default) range 1024-4999 is enough to issue up to 2000 connections per second to systems supporting timestamps. +ip_local_reserved_ports - list of comma separated ranges + Specify the ports which are reserved for known third-party + applications. These ports will not be used by automatic port + assignments (e.g. when calling connect() or bind() with port + number 0). Explicit port allocation behavior is unchanged. + + The format used for both input and output is a comma separated + list of ranges (e.g. "1,2-4,10-10" for ports 1, 2, 3, 4 and + 10). Writing to the file will clear all previously reserved + ports and update the current list with the one given in the + input. + + Note that ip_local_port_range and ip_local_reserved_ports + settings are independent and both are considered by the kernel + when determining which ports are available for automatic port + assignments. + + You can reserve ports which are not in the current + ip_local_port_range, e.g.: + + $ cat /proc/sys/net/ipv4/ip_local_port_range + 32000 61000 + $ cat /proc/sys/net/ipv4/ip_local_reserved_ports + 8080,9148 + + although this is redundant. However such a setting is useful + if later the port range is changed to a value that will + include the reserved ports. + + Default: Empty + ip_nonlocal_bind - BOOLEAN If set, allows processes to bind() to non-local IP addresses, which can be quite useful - but may break some applications. @@ -692,6 +747,25 @@ proxy_arp - BOOLEAN conf/{all,interface}/proxy_arp is set to TRUE, it will be disabled otherwise +proxy_arp_pvlan - BOOLEAN + Private VLAN proxy arp. + Basically allow proxy arp replies back to the same interface + (from which the ARP request/solicitation was received). + + This is done to support (ethernet) switch features, like RFC + 3069, where the individual ports are NOT allowed to + communicate with each other, but they are allowed to talk to + the upstream router. As described in RFC 3069, it is possible + to allow these hosts to communicate through the upstream + router by proxy_arp'ing. Don't need to be used together with + proxy_arp. + + This technology is known by different names: + In RFC 3069 it is called VLAN Aggregation. + Cisco and Allied Telesyn call it Private VLAN. + Hewlett-Packard call it Source-Port filtering or port-isolation. + Ericsson call it MAC-Forced Forwarding (RFC Draft). + shared_media - BOOLEAN Send(router) or accept(host) RFC1620 shared media redirects. Overrides ip_secure_redirects. @@ -829,13 +903,22 @@ arp_ignore - INTEGER arp_notify - BOOLEAN Define mode for notification of address and device changes. 0 - (default): do nothing - 1 - Generate gratuitous arp replies when device is brought up + 1 - Generate gratuitous arp requests when device is brought up or hardware address changes. arp_accept - BOOLEAN - Define behavior when gratuitous arp replies are received: - 0 - drop gratuitous arp frames - 1 - accept gratuitous arp frames + Define behavior for gratuitous ARP frames who's IP is not + already present in the ARP table: + 0 - don't create new entries in the ARP table + 1 - create new entries in the ARP table + + Both replies and requests type gratuitous arp will trigger the + ARP table to be updated, if this setting is on. + + If the ARP table already contains the IP address of the + gratuitous arp frame, the arp table will be updated regardless + if this setting is on or off. + app_solicit - INTEGER The maximum number of probes to send to the user space ARP daemon @@ -1074,10 +1157,10 @@ regen_max_retry - INTEGER Default: 5 max_addresses - INTEGER - Number of maximum addresses per interface. 0 disables limitation. - It is recommended not set too large value (or 0) because it would - be too easy way to crash kernel to allow to create too much of - autoconfigured addresses. + Maximum number of autoconfigured addresses per interface. Setting + to zero disables the limitation. It is not recommended to set this + value too large (or to zero) because it would be an easy way to + crash the kernel by allowing too many addresses to be created. Default: 16 disable_ipv6 - BOOLEAN |