#ifndef _ASM_X86_PGTABLE_3LEVEL_H #define _ASM_X86_PGTABLE_3LEVEL_H /* * Intel Physical Address Extension (PAE) Mode - three-level page * tables on PPro+ CPUs. * * Copyright (C) 1999 Ingo Molnar */ #define pte_ERROR(e) \ pr_err("%s:%d: bad pte %p(%08lx%08lx)\n", \ __FILE__, __LINE__, &(e), (e).pte_high, (e).pte_low) #define pmd_ERROR(e) \ pr_err("%s:%d: bad pmd %p(%016Lx)\n", \ __FILE__, __LINE__, &(e), pmd_val(e)) #define pgd_ERROR(e) \ pr_err("%s:%d: bad pgd %p(%016Lx)\n", \ __FILE__, __LINE__, &(e), pgd_val(e)) /* Rules for using set_pte: the pte being assigned *must* be * either not present or in a state where the hardware will * not attempt to update the pte. In places where this is * not possible, use pte_get_and_clear to obtain the old pte * value and then use set_pte to update it. -ben */ static inline void native_set_pte(pte_t *ptep, pte_t pte) { ptep->pte_high = pte.pte_high; smp_wmb(); ptep->pte_low = pte.pte_low; } #define pmd_read_atomic pmd_read_atomic /* * pte_offset_map_lock on 32bit PAE kernels was reading the pmd_t with * a "*pmdp" dereference done by gcc. Problem is, in certain places * where pte_offset_map_lock is called, concurrent page faults are * allowed, if the mmap_sem is hold for reading. An example is mincore * vs page faults vs MADV_DONTNEED. On the page fault side * pmd_populate rightfully does a set_64bit, but if we're reading the * pmd_t with a "*pmdp" on the mincore side, a SMP race can happen * because gcc will not read the 64bit of the pmd atomically. To fix * this all places running pmd_offset_map_lock() while holding the * mmap_sem in read mode, shall read the pmdp pointer using this * function to know if the pmd is null nor not, and in turn to know if * they can run pmd_offset_map_lock or pmd_trans_huge or other pmd * operations. * * Without THP if the mmap_sem is hold for reading, the pmd can only * transition from null to not null while pmd_read_atomic runs. So * we can always return atomic pmd values with this function. * * With THP if the mmap_sem is hold for reading, the pmd can become * trans_huge or none or point to a pte (and in turn become "stable") * at any time under pmd_read_atomic. We could read it really * atomically here with a atomic64_read for the THP enabled case (and * it would be a whole lot simpler), but to avoid using cmpxchg8b we * only return an atomic pmdval if the low part of the pmdval is later * found stable (i.e. pointing to a pte). And we're returning a none * pmdval if the low part of the pmd is none. In some cases the high * and low part of the pmdval returned may not be consistent if THP is * enabled (the low part may point to previously mapped hugepage, * while the high part may point to a more recently mapped hugepage), * but pmd_none_or_trans_huge_or_clear_bad() only needs the low part * of the pmd to be read atomically to decide if the pmd is unstable * or not, with the only exception of when the low part of the pmd is * zero in which case we return a none pmd. */ static inline pmd_t pmd_read_atomic(pmd_t *pmdp) { pmdval_t ret; u32 *tmp = (u32 *)pmdp; ret = (pmdval_t) (*tmp); if (ret) { /* * If the low part is null, we must not read the high part * or we can end up with a partial pmd. */ smp_rmb(); ret |= ((pmdval_t)*(tmp + 1)) << 32; } return (pmd_t) { ret }; } static inline void native_set_pte_atomic(pte_t *ptep, pte_t pte) { set_64bit((unsigned long long *)(ptep), native_pte_val(pte)); } static inline void native_set_pmd(pmd_t *pmdp, pmd_t pmd) { set_64bit((unsigned long long *)(pmdp), native_pmd_val(pmd)); } static inline void native_set_pud(pud_t *pudp, pud_t pud) { set_64bit((unsigned long long *)(pudp), native_pud_val(pud)); } /* * For PTEs and PDEs, we must clear the P-bit first when clearing a page table * entry, so clear the bottom half first and enforce ordering with a compiler * barrier. */ static inline void native_pte_clear(struct mm_struct *mm, unsigned long addr, pte_t *ptep) { ptep->pte_low = 0; smp_wmb(); ptep->pte_high = 0; } static inline void native_pmd_clear(pmd_t *pmd) { u32 *tmp = (u32 *)pmd; *tmp = 0; smp_wmb(); *(tmp + 1) = 0; } static inline void pud_clear(pud_t *pudp) { set_pud(pudp, __pud(0)); /* * According to Intel App note "TLBs, Paging-Structure Caches, * and Their Invalidation", April 2007, document 317080-001, * section 8.1: in PAE mode we explicitly have to flush the * TLB via cr3 if the top-level pgd is changed... * * Currently all places where pud_clear() is called either have * flush_tlb_mm() followed or don't need TLB flush (x86_64 code or * pud_clear_bad()), so we don't need TLB flush here. */ } #ifdef CONFIG_SMP static inline pte_t native_ptep_get_and_clear(pte_t *ptep) { pte_t res; /* xchg acts as a barrier before the setting of the high bits */ res.pte_low = xchg(&ptep->pte_low, 0); res.pte_high = ptep->pte_high; ptep->pte_high = 0; return res; } #else #define native_ptep_get_and_clear(xp) native_local_ptep_get_and_clear(xp) #endif #ifdef CONFIG_SMP union split_pmd { struct { u32 pmd_low; u32 pmd_high; }; pmd_t pmd; }; static inline pmd_t native_pmdp_get_and_clear(pmd_t *pmdp) { union split_pmd res, *orig = (union split_pmd *)pmdp; /* xchg acts as a barrier before setting of the high bits */ res.pmd_low = xchg(&orig->pmd_low, 0); res.pmd_high = orig->pmd_high; orig->pmd_high = 0; return res.pmd; } #else #define native_pmdp_get_and_clear(xp) native_local_pmdp_get_and_clear(xp) #endif /* * Bits 0, 6 and 7 are taken in the low part of the pte, * put the 32 bits of offset into the high part. */ #define pte_to_pgoff(pte) ((pte).pte_high) #define pgoff_to_pte(off) \ ((pte_t) { { .pte_low = _PAGE_FILE, .pte_high = (off) } }) #define PTE_FILE_MAX_BITS 32 /* Encode and de-code a swap entry */ #define MAX_SWAPFILES_CHECK() BUILD_BUG_ON(MAX_SWAPFILES_SHIFT > 5) #define __swp_type(x) (((x).val) & 0x1f) #define __swp_offset(x) ((x).val >> 5) #define __swp_entry(type, offset) ((swp_entry_t){(type) | (offset) << 5}) #define __pte_to_swp_entry(pte) ((swp_entry_t){ (pte).pte_high }) #define __swp_entry_to_pte(x) ((pte_t){ { .pte_high = (x).val } }) #endif /* _ASM_X86_PGTABLE_3LEVEL_H */