From 5e2672132dbdb79a7d70711ca5c4bd1fa770b7bd Mon Sep 17 00:00:00 2001 From: Mika Westerberg Date: Tue, 1 Oct 2013 17:35:43 +0300 Subject: gpio/lynxpoint: check if the interrupt is enabled in IRQ handler commit 03d152d5582abc8a1c19cb107164c3724bbd4be4 upstream. Checking LP_INT_STAT is not enough in the interrupt handler because its contents get updated regardless of whether the pin has interrupt enabled or not. This causes the driver to loop forever for GPIOs that are pulled up. Fix this by checking the interrupt enable bit for the pin as well. Signed-off-by: Mika Westerberg Acked-by: Mathias Nyman Signed-off-by: Linus Walleij Signed-off-by: Greg Kroah-Hartman --- drivers/gpio/gpio-lynxpoint.c | 5 +++-- 1 file changed, 3 insertions(+), 2 deletions(-) diff --git a/drivers/gpio/gpio-lynxpoint.c b/drivers/gpio/gpio-lynxpoint.c index 86c17de8769..71d86143aec 100644 --- a/drivers/gpio/gpio-lynxpoint.c +++ b/drivers/gpio/gpio-lynxpoint.c @@ -248,14 +248,15 @@ static void lp_gpio_irq_handler(unsigned irq, struct irq_desc *desc) struct lp_gpio *lg = irq_data_get_irq_handler_data(data); struct irq_chip *chip = irq_data_get_irq_chip(data); u32 base, pin, mask; - unsigned long reg, pending; + unsigned long reg, ena, pending; unsigned virq; /* check from GPIO controller which pin triggered the interrupt */ for (base = 0; base < lg->chip.ngpio; base += 32) { reg = lp_gpio_reg(&lg->chip, base, LP_INT_STAT); + ena = lp_gpio_reg(&lg->chip, base, LP_INT_ENABLE); - while ((pending = inl(reg))) { + while ((pending = (inl(reg) & inl(ena)))) { pin = __ffs(pending); mask = BIT(pin); /* Clear before handling so we don't lose an edge */ -- cgit v1.2.3