# # 1-wire slaves configuration # menu "1-wire Slaves" config W1_SLAVE_THERM tristate "Thermal family implementation" help Say Y here if you want to connect 1-wire thermal sensors to your wire. config W1_SLAVE_SMEM tristate "Simple 64bit memory family implementation" help Say Y here if you want to connect 1-wire simple 64bit memory rom(ds2401/ds2411/ds1990*) to your wire. config W1_SLAVE_DS2423 tristate "Counter 1-wire device (DS2423)" select CRC16 help If you enable this you can read the counter values available in the DS2423 chipset from the w1_slave file under the sys file system. Say Y here if you want to use a 1-wire counter family device (DS2423). config W1_SLAVE_DS2431 tristate "1kb EEPROM family support (DS2431)" help Say Y here if you want to use a 1-wire 1kb EEPROM family device (DS2431) config W1_SLAVE_DS2433 tristate "4kb EEPROM family support (DS2433)" help Say Y here if you want to use a 1-wire 4kb EEPROM family device (DS2433). config W1_SLAVE_DS2433_CRC bool "Protect DS2433 data with a CRC16" depends on W1_SLAVE_DS2433 select CRC16 help Say Y here to protect DS2433 data with a CRC16. Each block has 30 bytes of data and a two byte CRC16. Full block writes are only allowed if the CRC is valid. config W1_SLAVE_DS2760 tristate "Dallas 2760 battery monitor chip (HP iPAQ & others)" depends on W1 help If you enable this you will have the DS2760 battery monitor chip support. The battery monitor chip is used in many batteries/devices as the one who is responsible for charging/discharging/monitoring Li+ batteries. If you are unsure, say N. config W1_SLAVE_BQ27000 tristate "BQ27000 slave support" depends on W1 help Say Y here if you want to use a hdq bq27000 slave support. endmenu