diff options
Diffstat (limited to 'arch/blackfin/mach-bf518/include')
4 files changed, 37 insertions, 61 deletions
diff --git a/arch/blackfin/mach-bf518/include/mach/anomaly.h b/arch/blackfin/mach-bf518/include/mach/anomaly.h index b69bd9af38d..753ed810e1c 100644 --- a/arch/blackfin/mach-bf518/include/mach/anomaly.h +++ b/arch/blackfin/mach-bf518/include/mach/anomaly.h @@ -7,7 +7,7 @@ */ /* This file should be up to date with: - * - Revision B, 02/03/2009; ADSP-BF512/BF514/BF516/BF518 Blackfin Processor Anomaly List + * - Revision C, 06/12/2009; ADSP-BF512/BF514/BF516/BF518 Blackfin Processor Anomaly List */ /* We plan on not supporting 0.0 silicon, but 0.1 isn't out yet - sorry */ @@ -18,7 +18,7 @@ #ifndef _MACH_ANOMALY_H_ #define _MACH_ANOMALY_H_ -/* Multi-issue instruction with dsp32shiftimm in slot1 and P-reg store in slot 2 not supported */ +/* Multi-Issue Instruction with dsp32shiftimm in slot1 and P-reg Store in slot2 Not Supported */ #define ANOMALY_05000074 (1) /* Rx.H Cannot Be Used to Access 16-bit System MMR Registers */ #define ANOMALY_05000122 (1) @@ -45,29 +45,31 @@ /* Speculative Fetches of Indirect-Pointer Instructions Can Cause False Hardware Errors */ #define ANOMALY_05000426 (1) /* Software System Reset Corrupts PLL_LOCKCNT Register */ -#define ANOMALY_05000430 (1) +#define ANOMALY_05000430 (__SILICON_REVISION__ < 1) /* Incorrect Use of Stack in Lockbox Firmware During Authentication */ #define ANOMALY_05000431 (1) /* Certain SIC Registers are not Reset After Soft or Core Double Fault Reset */ -#define ANOMALY_05000435 (1) +#define ANOMALY_05000435 (__SILICON_REVISION__ < 1) /* PORTx_DRIVE and PORTx_HYSTERESIS Registers Read Back Incorrect Values */ -#define ANOMALY_05000438 (1) +#define ANOMALY_05000438 (__SILICON_REVISION__ < 1) /* Preboot Cannot be Used to Alter the PLL_DIV Register */ -#define ANOMALY_05000439 (1) +#define ANOMALY_05000439 (__SILICON_REVISION__ < 1) /* bfrom_SysControl() Cannot be Used to Write the PLL_DIV Register */ -#define ANOMALY_05000440 (1) +#define ANOMALY_05000440 (__SILICON_REVISION__ < 1) /* IFLUSH Instruction at End of Hardware Loop Causes Infinite Stall */ #define ANOMALY_05000443 (1) /* Incorrect L1 Instruction Bank B Memory Map Location */ -#define ANOMALY_05000444 (1) +#define ANOMALY_05000444 (__SILICON_REVISION__ < 1) /* Incorrect Default Hysteresis Setting for RESET, NMI, and BMODE Signals */ -#define ANOMALY_05000452 (1) +#define ANOMALY_05000452 (__SILICON_REVISION__ < 1) /* PWM_TRIPB Signal Not Available on PG10 */ -#define ANOMALY_05000453 (1) +#define ANOMALY_05000453 (__SILICON_REVISION__ < 1) /* PPI_FS3 is Driven One Half Cycle Later Than PPI Data */ -#define ANOMALY_05000455 (1) -/* False Hardware Error when RETI points to invalid memory */ +#define ANOMALY_05000455 (__SILICON_REVISION__ < 1) +/* False Hardware Error when RETI Points to Invalid Memory */ #define ANOMALY_05000461 (1) +/* Synchronization Problem at Startup May Cause SPORT Transmit Channels to Misalign */ +#define ANOMALY_05000462 (1) /* Anomalies that don't exist on this proc */ #define ANOMALY_05000099 (0) @@ -78,24 +80,31 @@ #define ANOMALY_05000158 (0) #define ANOMALY_05000171 (0) #define ANOMALY_05000179 (0) +#define ANOMALY_05000182 (0) #define ANOMALY_05000183 (0) +#define ANOMALY_05000189 (0) #define ANOMALY_05000198 (0) +#define ANOMALY_05000202 (0) #define ANOMALY_05000215 (0) #define ANOMALY_05000220 (0) #define ANOMALY_05000227 (0) #define ANOMALY_05000230 (0) #define ANOMALY_05000231 (0) #define ANOMALY_05000233 (0) +#define ANOMALY_05000234 (0) #define ANOMALY_05000242 (0) #define ANOMALY_05000244 (0) #define ANOMALY_05000248 (0) #define ANOMALY_05000250 (0) +#define ANOMALY_05000257 (0) #define ANOMALY_05000261 (0) #define ANOMALY_05000263 (0) #define ANOMALY_05000266 (0) #define ANOMALY_05000273 (0) #define ANOMALY_05000274 (0) #define ANOMALY_05000278 (0) +#define ANOMALY_05000281 (0) +#define ANOMALY_05000283 (0) #define ANOMALY_05000285 (0) #define ANOMALY_05000287 (0) #define ANOMALY_05000301 (0) @@ -103,10 +112,14 @@ #define ANOMALY_05000307 (0) #define ANOMALY_05000311 (0) #define ANOMALY_05000312 (0) +#define ANOMALY_05000315 (0) #define ANOMALY_05000323 (0) #define ANOMALY_05000353 (0) +#define ANOMALY_05000357 (0) #define ANOMALY_05000362 (1) #define ANOMALY_05000363 (0) +#define ANOMALY_05000364 (0) +#define ANOMALY_05000371 (0) #define ANOMALY_05000380 (0) #define ANOMALY_05000386 (0) #define ANOMALY_05000389 (0) @@ -117,5 +130,7 @@ #define ANOMALY_05000448 (0) #define ANOMALY_05000456 (0) #define ANOMALY_05000450 (0) +#define ANOMALY_05000465 (0) +#define ANOMALY_05000467 (0) #endif diff --git a/arch/blackfin/mach-bf518/include/mach/bfin_serial_5xx.h b/arch/blackfin/mach-bf518/include/mach/bfin_serial_5xx.h index 0fb2ce5d840..dbade93395e 100644 --- a/arch/blackfin/mach-bf518/include/mach/bfin_serial_5xx.h +++ b/arch/blackfin/mach-bf518/include/mach/bfin_serial_5xx.h @@ -53,7 +53,7 @@ #define UART_SET_DLAB(uart) do { UART_PUT_LCR(uart, UART_GET_LCR(uart) | DLAB); SSYNC(); } while (0) #define UART_CLEAR_DLAB(uart) do { UART_PUT_LCR(uart, UART_GET_LCR(uart) & ~DLAB); SSYNC(); } while (0) -#define UART_GET_CTS(x) (!gpio_get_value(x->cts_pin)) +#define UART_GET_CTS(x) gpio_get_value(x->cts_pin) #define UART_DISABLE_RTS(x) gpio_set_value(x->rts_pin, 1) #define UART_ENABLE_RTS(x) gpio_set_value(x->rts_pin, 0) #define UART_ENABLE_INTS(x, v) UART_PUT_IER(x, v) diff --git a/arch/blackfin/mach-bf518/include/mach/blackfin.h b/arch/blackfin/mach-bf518/include/mach/blackfin.h index 267bb7c8bfb..e8e14c2769e 100644 --- a/arch/blackfin/mach-bf518/include/mach/blackfin.h +++ b/arch/blackfin/mach-bf518/include/mach/blackfin.h @@ -33,7 +33,6 @@ #define _MACH_BLACKFIN_H_ #include "bf518.h" -#include "mem_map.h" #include "defBF512.h" #include "anomaly.h" diff --git a/arch/blackfin/mach-bf518/include/mach/mem_map.h b/arch/blackfin/mach-bf518/include/mach/mem_map.h index 62bcc781bfa..3c6777cb353 100644 --- a/arch/blackfin/mach-bf518/include/mach/mem_map.h +++ b/arch/blackfin/mach-bf518/include/mach/mem_map.h @@ -1,38 +1,16 @@ /* - * file: include/asm-blackfin/mach-bf518/mem_map.h - * based on: include/asm-blackfin/mach-bf527/mem_map.h - * author: Bryan Wu <cooloney@kernel.org> + * BF51x memory map * - * created: - * description: - * Memory MAP Common header file for blackfin BF518/6/4/2 of processors. - * rev: - * - * modified: - * - * bugs: enter bugs at http://blackfin.uclinux.org/ - * - * this program is free software; you can redistribute it and/or modify - * it under the terms of the gnu general public license as published by - * the free software foundation; either version 2, or (at your option) - * any later version. - * - * this program is distributed in the hope that it will be useful, - * but without any warranty; without even the implied warranty of - * merchantability or fitness for a particular purpose. see the - * gnu general public license for more details. - * - * you should have received a copy of the gnu general public license - * along with this program; see the file copying. - * if not, write to the free software foundation, - * 59 temple place - suite 330, boston, ma 02111-1307, usa. + * Copyright 2004-2009 Analog Devices Inc. + * Licensed under the GPL-2 or later. */ -#ifndef _MEM_MAP_518_H_ -#define _MEM_MAP_518_H_ +#ifndef __BFIN_MACH_MEM_MAP_H__ +#define __BFIN_MACH_MEM_MAP_H__ -#define COREMMR_BASE 0xFFE00000 /* Core MMRs */ -#define SYSMMR_BASE 0xFFC00000 /* System MMRs */ +#ifndef __BFIN_MEM_MAP_H__ +# error "do not include mach/mem_map.h directly -- use asm/mem_map.h" +#endif /* Async Memory Banks */ #define ASYNC_BANK3_BASE 0x20300000 /* Async Bank 3 */ @@ -89,20 +67,4 @@ #define BFIN_DSUPBANKS 0 #endif /*CONFIG_BFIN_DCACHE */ -/* Level 2 Memory - none */ - -#define L2_START 0 -#define L2_LENGTH 0 - -/* Scratch Pad Memory */ - -#define L1_SCRATCH_START 0xFFB00000 -#define L1_SCRATCH_LENGTH 0x1000 - -#define GET_PDA_SAFE(preg) \ - preg.l = _cpu_pda; \ - preg.h = _cpu_pda; - -#define GET_PDA(preg, dreg) GET_PDA_SAFE(preg) - -#endif /* _MEM_MAP_518_H_ */ +#endif |