Freescale MPC8315ERDB Board ----------------------------------------- 1. Board Switches and Jumpers S3 is used to set CONFIG_SYS_RESET_SOURCE. To boot the image at 0xFE000000 in NOR flash, use these DIP switch settings for S3 S4: +------+ +------+ | | | **** | | **** | | | +------+ ON +------+ ON 4321 4321 (where the '*' indicates the position of the tab of the switch.) 2. Memory Map The memory map looks like this: 0x0000_0000 0x07ff_ffff DDR 128M 0x8000_0000 0x8fff_ffff PCI MEM 256M 0x9000_0000 0x9fff_ffff PCI_MMIO 256M 0xe000_0000 0xe00f_ffff IMMR 1M 0xe030_0000 0xe03f_ffff PCI IO 1M 0xe060_0000 0xe060_7fff NAND FLASH (CS1) 32K 0xfe00_0000 0xfe7f_ffff NOR FLASH (CS0) 8M 3. Definitions 3.1 Explanation of NEW definitions in: include/configs/MPC8315ERDB.h CONFIG_MPC83xx MPC83xx family CONFIG_MPC831x MPC831x specific CONFIG_MPC8315 MPC8315 specific CONFIG_MPC8315ERDB MPC8315ERDB board specific 4. Compilation Assuming you're using BASH (or similar) as your shell: export CROSS_COMPILE=your-cross-compiler-prefix- make distclean make MPC8315ERDB_config make all 5. Downloading and Flashing Images 5.1 Reflash U-boot Image using U-boot tftp 40000 u-boot.bin protect off all erase fe000000 fe1fffff cp.b 40000 fe000000 xxxx protect on all You have to supply the correct byte count with 'xxxx' from the TFTP result log. 5.2 Downloading and Booting Linux Kernel Ensure that all networking-related environment variables are set properly (including ipaddr, serverip, gatewayip (if needed), netmask, ethaddr, eth1addr, rootpath (if using NFS root), fdtfile, and bootfile). Then, do one of the following, depending on whether you want an NFS root or a ramdisk root: =>run nfsboot or =>run ramboot 6 Notes Booting from NAND flash is not yet supported. The console baudrate for MPC8315ERDB is 115200bps.